Modeling of neutral pressure and pumping in the Tore Supra ergodic divertor and outboard pump limiter

Active control of the core plasma density and partial depletion of the wall particle content have been achieved in experiments on Tore Supra with the plasma leaning on either the ergodic divertor (ED) or the pump limiters. Measurements of neutral pressures in the ED and outboard pump limiter (OPL) are modeled with 1D parallel transport equations (continuity and momentum balance) for the SOL plasma coupled to 2D neutral particle transport simulations. SOL density and temperature profiles from reciprocating Langmuir probe measurements for a range of volume-averaged densities are renormalized, where necessary, to agree with Langmuir probe measurements in the OPL throat and constitute the upstream boundary conditions for the 1D calculations. Good agreement with measured pressures and exhaust rates are obtained for both the ED and OPL in scans that span a factor of 2-3 in volume-averaged density. The importance of a self-consistent treatment of the plasma and neutral particle transport in the neighborhood of the neutralizer plate is demonstrated, particularly in the stranger recycling regimes characteristic of densities at the high end of the scans. Plasma flow reversal near the plasma/plenum interface is predicted to occur at the higher densities due to the large local ionization source. Predictions of pressure buildup in the plenum behind the prototype vented neutralizer plate agree with experiment if it is assumed that both the tops and partially the sides of the needles comprising the plate are wetted by the plasma. A discharge in which the ED pumps are active is analyzed; the calculated pressure and exhaust rate agree with experiment. The core fueling rate is the same as without pumping, suggesting, as is seen in the experiment, a small density decay rate and significant wall particle depletion.