Dynamic Mechanical Responses of Ultrafine-Grained IF Steel Over a Wide Range of Temperatures

The ultrafine-grained interstitial free (UFG-Ill steel was fabricated using the equal channel angular pressing (ECAP) method. Transmission electronic microscope (TEM) observations showed that the grains were refined to sub-micrometer scale and the average grain size was several hundred nanometers (nm). Uniaxial compression tests were conducted over a wide range of strain rates (up to 6000/s) and temperatures (from -196 degrees C to 300 degrees C) to understand the dependence of mechanical behaviors on the strain rate and temperature. It is found that the UFG-IF steel showed a weak strain rate sensitivity and displayed a strong temperature sensitivity only within a very narrow temperature range. Microstructurel observations on the specimens deformed dynamically at temperatures below -20 degrees C via scanning electronic microscopy (SEM) and TEM indicated the occurrence of adiabatic shear localization. In order to explain the reason why adiabatic shear localization formed at the low temperatures and high strain rates, the susceptibility factor to adiabatic shear band (ASB) was estimated. It is proposed that more heat generated during the adiabatic plastic deformation process due to the enhanced flow stress of the UFG-IF steel at lower temperatures may play a dominant role in the formation of ASB. Meanwhile, the experimental results also provide strong evidence that for the UFG-IF steel the dynamic recrystallization which results from the severe plastic deformation and high temperature rise only occurs at the later stage of ASB evolution. With regard to the formation of ASB in the UFG IF steel, the localized plastic flow at a lower stress level indicates that localized deformation happens firstly and the temperature rise in the localized shearing zone leads to the final plastic instability.