A laterally-driven micromachined inertial switch with a compliant cantilever beam as the stationary electrode for prolonging contact time

A novel micro-electromechanical systems inertial switch based on non-silicon surface micromachining technology has been designed, fabricated and characterized in the present work. Compared with the traditional inertial switch, a compliant cantilever beam as a stationary electrode has been proposed to prolong the contact time, which can realize sufficient elastic deformation during the contact between the electrodes. The dynamic contact process is analyzed theoretically and the corresponding mechanical impact mechanism is also explained. To investigate the contact-enhancing mechanism of the cantilever beam, the switch applied half-sine acceleration with various amplitudes in the sensitive direction is simulated with ANSYS software. The dynamic simulation results confirm the contact-enhancing mechanism described by the theoretical analysis and it is shown that the contact time (i.e., the switch-on time) can be prolonged effectively by utilizing the elastic deformation of the cantilever beam and increased with the applied accelerations. The inertial switch is successfully fabricated by electroplating and sacrificial layer processes technologies. The prototype has been characterized by dropping hammer experiment. The test results indicate that the contact effect is improved significantly and the contact time is similar to 80 mu s under the 297 g acceleration, and the maximum value is similar to 410 mu s for the 672 g acceleration amplitude, which is in general accordance with the simulated results. The mechanical contact between the cantilever beam and the proof mass is evaluated following thousands of impacts. The scanning electron micrographs of the contact surfaces indicate that the all-metal switch still keeps a good mechanical property after suffering the hot contact, and the contact resistance is also stable.