Spatial analysis of CO poisoning in high temperature polymer electrolyte membrane fuel cells

The improved tolerance of the High Temperature-Polymer Electrolyte Membrane Fuel Cell (HT-PEMFC) to CO allows the use of reformate as an anode feed. However, the presence of several per cent of CO in the reformate, which is inevitable particularly in on-board reformation in automobiles, which otherwise demands complex systems to keep the CO level very low, will significantly lower the cell performance, especially when the HT-PEMFC is operated at 160 degrees C or below. In this study, a three-dimensional, non-isothermal numerical model is developed and applied to a single straight-channel HT-PEMFC geometry. The model is validated against the experimental data for a broad range of current densities at different CO concentration and operating temperatures. A significant spatial variation in current density distribution is observed in the membrane because the CO sorption is a spatially non-homogeneous process depending on local operating conditions and dilution of the H-2 stream. To investigate the local spatial effects on HT-PEMFC operation, the model is applied to a real cell of size 49.4 cm(2) with an 8-pass serpentine flow-field at the anode and the cathode. The membrane and anode catalyst layer are segmented into 5 x 5 array to investigate the spatial resolution of the polarization curves, H-2 concentration, current density, and anode polarization loss. The simulation results show that the presence of CO in the anode feed reduces cell performance, however, the results reveal that uniformity in current density distribution in the membrane improves when the cell is operated in potentiostatic mode. The results are discussed in detail with the help of several line plots and multi-dimensional contours. The study also emphasizes on the importance of optimizing the reformate anode feed rate to improve cell performance. (c) 2020 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.