Influence of content of carbon fabric on the low amplitude oscillating wear performance of polyetherimide composites

Tribo-potential of bi-directionally (BD) reinforced polymer composites is not yet adequately explored especially in low amplitude oscillating wear (LAOW)/fretting wear mode. Hence five composites of Polyetherimide (PEI) containing carbon fabric (plain weave) in the range 40-85 by vol% were developed by impregnation technique followed by compression molding. These composites along with unfilled PEI were evaluated for their LAOW performance on SRV Optimol tester under different loads using ball-on-plate configuration. The performance was compared with that of composite evaluated in earlier work but developed with different processing technique (hand lay up). With increase in load, specific wear rates of all the composites increased while friction coefficient (mu) decreased. It was concluded that carbon fabric inclusion in all amounts proved significantly beneficial for improving friction and wear performance and limiting load of PEI. Very high and very low amount of CF (85 and 40 vol%) proved least beneficial from strength and tribo-performance point of view. Composites with moderate amount of CF (65 and 55 vol%) proved most promising with almost similar potential in reducing mu and wear rate of PEI. Overall CF in the range of 55-65 vol% appeared to be the optimum range for tailoring the strength properties along with tribo-performance in fretting wear mode. The impregnation technique proved significantly better than the hand lay up technique for enhancement in strength and tribo-performance. SEM studies on worn surface proved helpful in understanding wear mechanisms.