Saturation Independent Detection of Dynamic Eccentricity Fault in Salient-Pole Synchronous Machines

被引:0
|
作者
Ilamparithi, T. [1 ]
Nandi, Subhasis [2 ]
机构
[1] RT Technol, OPAL, Montreal, PQ, Canada
[2] Univ Victoria, Dept Elect & Comp Engn, Victoria, BC, Canada
来源
2013 9TH IEEE INTERNATIONAL SYMPOSIUM ON DIAGNOSTICS FOR ELECTRIC MACHINES, POWER ELECTRONICS AND DRIVES (SDEMPED) | 2013年
基金
加拿大自然科学与工程研究理事会;
关键词
condition monitoring; eccentricity; frequency spectrum; finite element; saturation; synchronous machine;
D O I
暂无
中图分类号
TM [电工技术]; TN [电子技术、通信技术];
学科分类号
0808 ; 0809 ;
摘要
This paper proposes a novel scheme based on current signature analysis to estimate the severity of dynamic eccentricity fault independent of saturation in salient-pole synchronous machines (SPSM). The detection technique uses short circuit test data and exploits the presence of inherent static eccentricity in a machine. Implementation of the scheme involves two steps. First, the percentage increases in both mixed eccentricity component and static eccentricity component are computed. Then the difference between them is used as a factor to estimate the severity of dynamic eccentricity. The method is also found capable of distinguishing between static and dynamic eccentricity faults. Results obtained from an experimental 3 phase, 2.2 kW machine have been used to validate the proposed eccentricity severity estimation scheme.
引用
收藏
页码:336 / 341
页数:6
相关论文
共 50 条
  • [21] Spiral vector theory applied to salient-pole synchronous machine
    Touhami, O
    Menaa, M
    Ibtiouen, R
    Benhaddadi, M
    SYSTEM STRUCTURE AND CONTROL 1997, 1998, : 499 - 504
  • [22] Non-invasive Detection of Winding Short-circuit Faults in Salient-pole Synchronous Machine
    Cuevas, Mauricio
    Romary, Raphael
    Lecointe, Jean-Philippe
    Morganti, Fabrice
    Jacq, Thierry
    2017 IEEE INTERNATIONAL ELECTRIC MACHINES AND DRIVES CONFERENCE (IEMDC), 2017,
  • [23] The device to measuring of the load angle for salient-pole synchronous machine in education laboratory
    Kanuch, Jan
    Girovsky, Peter
    MEASUREMENT, 2018, 116 : 49 - 55
  • [24] Methods for d-/q-Axis Saturation Stator-to-Rotor Mutual Inductance of Salient-Pole Synchronous Machine
    Wang, Hongyu
    2017 IEEE ENERGY CONVERSION CONGRESS AND EXPOSITION (ECCE), 2017, : 3195 - 3200
  • [25] MODELING AND SIMULATION OF DYNAMICAL PROCESSES IN HIGH POWER SALIENT POLE SYNCHRONOUS MACHINES
    Campeanu, Aurel
    Stiebler, Manfred
    REVUE ROUMAINE DES SCIENCES TECHNIQUES-SERIE ELECTROTECHNIQUE ET ENERGETIQUE, 2011, 56 (02): : 179 - 188
  • [26] Prediction of Efficiency-optimized Salient-pole Synchronous Machines' Operating Range Using a Coupled Numerical-Analytical Method
    Korolova, O.
    Dueck, P.
    Brune, A.
    Juergens, J.
    Ponick, B.
    2014 INTERNATIONAL CONFERENCE ON ELECTRICAL MACHINES (ICEM), 2014, : 871 - 876
  • [27] RELUCTANCE DISTRIBUTION MODELING OF SATURATED SALIENT POLE SYNCHRONOUS MACHINES
    GORDON, C
    BARTON, TH
    IEEE TRANSACTIONS ON ENERGY CONVERSION, 1994, 9 (02) : 323 - 329
  • [28] Design of a salient-pole synchronous reluctance machine for an industrial drive considering sensorless operation
    Hofer, M.
    Nikowitz, M.
    Schroedl, M.
    ELEKTROTECHNIK UND INFORMATIONSTECHNIK, 2018, 135 (02): : 153 - 160
  • [29] Non-linear Optimization Approach to Determine Parameters of Small Salient-pole Synchronous Machines from the Short-circuit Test
    Tu, Xiaoping
    Dessaint, Louis-A
    Champagne, Roger
    Al-Haddad, Kamal
    ELECTRIC POWER COMPONENTS AND SYSTEMS, 2010, 38 (09) : 1076 - 1096
  • [30] Calculation of Circulating Currents in Parallel Branches of Salient Pole Synchronous Machines
    Schepe, C.
    Haschen, E.
    Ponick, B.
    2020 INTERNATIONAL CONFERENCE ON ELECTRICAL MACHINES (ICEM), VOL 1, 2020, : 2582 - 2588