GB5 Mix Design: High-Performance and Cost-Effective Asphalt Concretes by Use of Gap-Graded Curves and SBS Modified Bitumens

Aggregate packing concepts developed in the field of high-performance cement concretes, initially by Caquot (1937) then by contemporary researchers since the 1970's, were transposed to the field of asphalt concretes. These concepts, associated with the use of the gyratory compactor on aggregates only, enabled the development of a new laboratory design procedure of dense high-modulus asphalt concretes. These mixes are characterized by single or double gap-graded curves, great coarse aggregate interlock and no need for low penetration grade bitumens to fulfill the European EME2 specification requirements, in particular the 14,000 MPa stiffness modulus value at 15 degrees C. In addition, the use of polymer modified binders (PMB's), at a content of about 4% up to 4.5%, combined with such an optimized aggregate packing, leads to the design of so-called high-performance asphalt concretes (HPAs) characterized by great compactability, very high stiffness modulus and high fatigue resistance in a single formulation, allowing for reduced pavement thickness and increased longevity. Moreover, the proposed mix design and the 4-4.5% binder content make PMB's use affordable in base courses. Laboratory assessment of such materials consisted of the evaluation of compactability, moisture resistance, rutting resistance at 60 degrees C, complex stiffness modulus at 15 degrees C and fatigue resistance at 10 degrees C. Apart from these results, the paper also addresses the successful application of this new material on different job sites, located mainly in France. The proposed HPA material may be potentially considered as a relevant solution for sustainable long life pavements that do not deteriorate structurally, needing only timely surface maintenance.