A rolling contact fatigue crack driven by squeeze fluid film

A new model of surface breaking rolling contact fatigue (RCF) crack driven by a coupled action of a squeeze oil film built up in the crack interior and a pressure exerted at the external contact interface was developed. The model can be applied to the 'nominally dry' contact couples with an occasional presence of liquid in the crack interior (wheel/rail contact) as well as to the elastohydrodynamic lubrication (EHL) conditions. In the first case, the contact load is a result of solid/solid interaction and can be determined by solving the FE contact problem, but the liquid contained in the crack interior forms a thin film between the crack faces changing their interaction into the type of liquid/solid. This liquid is being periodically squeezed under contact load and acts as a 'squeeze film' known from the lubrication theory. In the second case, the liquid (lubricating oil) is permanently present in the contact area and consequently in the vicinity of the crack mouth. This creates conditions for filling the crack with oil. Similarly as in the first case, the 'squeez oil film' is built between the crack faces. The contact load in this case results from a liquid/solid interaction and can be approximated by the pressure and traction distributions obtained from the numerical solution of the elastohydrodynamic contact problem. In both cases the model can be used to determine the Linear Elastic Fracture Mechanics (LEFM) crack tip stress intensity histories during cyclic loading and consequently to predict the crack growth rate and direction. An example of applying the model to the EHL case is given to explain the mechanisms and phenomena leading to the crack front loading. The cycle of rolling a roller over the crack was numerically simulate to obtain the mixed mode (I and II) SIF histories. In the analysis, the EHD pressure and traction were determined through the full solution of the EHD line contact problem accounting for the presence of a crack, whilst the pressure in the crack was found with the use of the wedge shaped squeeze oil film (SOF) model. Possible effects of the mode I and mode II stress intensity cycles on crack growth rate and direction are discussed. The solution indicates high pressure in the neighbourhood of the crack tip, exerted on the crack faces by the squeeze oil film. This leads to the ranges of the mode I and mode II SIF variations, which are larger than the 'dry' and 'fluid entrapment' models, and can be an explanation for the crack growth rate observed in practice.