The relationship between kurtosis- and envelope-based indexes for the diagnostic of rolling element bearings

被引:225
作者
Borghesani, P. [1 ]
Pennacchi, P. [1 ]
Chatterton, S. [1 ]
机构
[1] Politecn Milan, Dipartimento Meccan, I-20156 Milan, Italy
关键词
Envelope analysis; Rolling element bearing; Kurtosis; Kurtogram; Cyclostationarity; SIGNALS; FAULTS;
D O I
10.1016/j.ymssp.2013.10.007
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
The coupling of kurtosis based-indexes and envelope analysis represents one of the most successful and widespread procedures for the diagnostics of incipient faults on rolling element bearings. Kurtosis-based indexes are often used to select the proper demodulation band for the application of envelope-based techniques. Kurtosis itself, in slightly different formulations, is applied for the prognostic and condition monitoring of rolling element bearings, as a standalone tool for a fast indication of the development of faults. This paper shows for the first time the strong analytical connection which holds for these two families of indexes. In particular, analytical identities are shown for the squared envelope spectrum (SES) and the kurtosis of the corresponding band-pass filtered analytic signal. In particular, it is demonstrated how the sum of the peaks in the SES corresponds to the raw 4th order moment. The analytical results show as well a link with an another signal processing technique: the cepstrum pre-whitening, recently used in bearing diagnostics. The analytical results are the basis for the discussion on an optimal indicator for the choice of the demodulation band, the ratio of cyclic content (RCC), which endows the kurtosis with selectivity in the cyclic frequency domain and whose performance is compared with more traditional kurtosis-based indicators such as the protrugram. A benchmark, performed on numerical simulations and experimental data coming from two different test-rigs, proves the superior effectiveness of such an indicator. Finally a short introduction to the potential offered by the newly proposed index in the field of prognostics is given in an additional experimental example. In particular the RCC is tested on experimental data collected on an endurance bearing test-rig, showing its ability to follow the development of the damage with a single numerical index. (C) 2013 Elsevier Ltd. All rights reserved.
引用
收藏
页码:25 / 43
页数:19
相关论文
共 25 条
[1]  
[Anonymous], 2011, P 2011 IEEE C PROGN
[2]   Cyclic spectral analysis of rolling-element bearing signals: Facts and fictions [J].
Antoni, J. .
JOURNAL OF SOUND AND VIBRATION, 2007, 304 (3-5) :497-529
[3]   The spectral kurtosis: application to the vibratory surveillance and diagnostics of rotating machines [J].
Antoni, J ;
Randall, RB .
MECHANICAL SYSTEMS AND SIGNAL PROCESSING, 2006, 20 (02) :308-331
[4]   Fast computation of the kurtogram for the detection of transient faults [J].
Antoni, Jerome .
MECHANICAL SYSTEMS AND SIGNAL PROCESSING, 2007, 21 (01) :108-124
[5]   Steam-whirl analysis in a high pressure cylinder of a turbo generator [J].
Bachschmid, Nicolo ;
Pennacchi, Paolo ;
Vania, Andrea .
MECHANICAL SYSTEMS AND SIGNAL PROCESSING, 2008, 22 (01) :121-132
[6]   A novel method for the optimal band selection for vibration signal demodulation and comparison with the Kurtogram [J].
Barszcz, Tomasz ;
Jablonski, Adam .
MECHANICAL SYSTEMS AND SIGNAL PROCESSING, 2011, 25 (01) :431-451
[7]  
Borges P., 2012, P ASME 2012 INT DES, P1
[8]   Testing second order cyclostationarity in the squared envelope spectrum of non-white vibration signals [J].
Borghesani, P. ;
Pennacchi, P. ;
Ricci, R. ;
Chatterton, S. .
MECHANICAL SYSTEMS AND SIGNAL PROCESSING, 2013, 40 (01) :38-55
[9]   Application of cepstrum pre-whitening for the diagnosis of bearing faults under variable speed conditions [J].
Borghesani, P. ;
Pennacchi, P. ;
Randall, R. B. ;
Sawalhi, N. ;
Ricci, R. .
MECHANICAL SYSTEMS AND SIGNAL PROCESSING, 2013, 36 (02) :370-384
[10]   A new procedure for using envelope analysis for rolling element bearing diagnostics in variable operating conditions [J].
Borghesani, P. ;
Ricci, R. ;
Chatterton, S. ;
Pennacchi, P. .
MECHANICAL SYSTEMS AND SIGNAL PROCESSING, 2013, 38 (01) :23-35