Nonlinear mechanical response of high density polyethylene .1. Experimental investigation and model evaluation

The nonlinear behavior of high density polyethylene (HDPE) is investigated for samples cut from thick-walled HDPE pipe. Extensive experimental work has been performed to characterize Vie non-linear time-dependent response of the material tested under uniaxial compression, Tests were conducted under conditions of constant strain rate, creep, stress relaxation, constant loading rate, abrupt change of strain rate, creep-recovery, cyclic strain rate, and various combinations of these loading conditions. Creep and stress relaxation response after strain reversal and the effect of the transient response on the following stress-strain behavior is examined, Permanent strains for the test specimens and their dependence on loading histories are investigated, Specimens cut at various orientations from the pipe are used to quantify the small amounts of local anisotropy in the pipe specimen. The experimental work has been used to develop both nonlinear viscoelastic (NVE) and viscoplastic (VP) constitutive models in a companion paper. Both the test results and the corresponding model predictions are reported in this paper. It is found that the VP model reproduces the nonlinear viscoelastic-viscoplastic behavior of HDPE very well provided that the current strain is not below the maximum strain imposed (there is no strain reversal). The NVE model predicts the material behavior reasonably well for some loading conditions, but inadequately for others.