Microstructural evolution of predeformed SiCp/ZA27 composites during partial remelting

被引:10
作者
Chen, TJ [1 ]
Hao, Y
Sun, J
机构
[1] Xian Jiaotong Univ, State Key Lab Mech Behav Mat, Xian 710049, Peoples R China
[2] Lanzhou Univ Technol, State Key Kab Adv Nonferrous Mat, Lanzhou 730050, Peoples R China
[3] Lanzhou Univ Technol, State Key Lab Gansu New Nonferrous Met Mat, Lanzhou 730050, Peoples R China
来源
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE | 2004年 / 35A卷 / 07期
关键词
D O I
10.1007/s11661-004-0156-y
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The microstructural evolution process in SiC particle (SiCp)-reinforced ZA27 composites, previously compressed by different lengths at 270 degreesC, was investigated during partial remelting. The results indicated that, after being compressed, the microstructure of SiCp/ZA27 composites changed gradually from developed primary alpha dendrites, to coarsened short dendrites, and then to a structure consisting of texture cells with different orientations with increasing compression. During subsequent partial remelting, the microstructure evolution exhibited four stages: initial rapid coarsening, structural separation, spheroidization, and final coarsening. The change of the primary a particle size with the heating time obeyed the law developed by Lifshitz and Slyosov and Wagner (LSW) after the semisolid system was up to the dynamic solid-liquid equilibrium state. High compression, high remelting temperature, and large size and proper content of SiC(p)s were beneficial to achieving a desirable structure for semisolid forming (SSF). The primary a particle size distribution was significantly affected by coalescence. These phenomena were extensively discussed metallographically and theoretically.
引用
收藏
页码:2073 / 2085
页数:13
相关论文
共 22 条
[11]   Microstructural evolution during partial remelting of Al-Si7Mg alloys [J].
Loue, WR ;
Suery, M .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1995, 203 (1-2) :1-13
[12]   Isothermal grain coarsening of spray formed alloys in the semi-solid state [J].
Manson-Whitton, ED ;
Stone, IC ;
Jones, JR ;
Grant, PS ;
Cantor, B .
ACTA MATERIALIA, 2002, 50 (10) :2517-2535
[13]  
Muthukumarasamy S, 1994, AFS T, V102, P819
[14]   Numerical analysis of purely diffusion controlled Ostwald ripening in a solid-liquid mixture [J].
Nomoto, S ;
Shiohara, Y ;
Umeda, T .
MATERIALS TRANSACTIONS JIM, 1999, 40 (12) :1413-1421
[15]   Ostwald ripening of solid-liquid Pb-Sn dispersions [J].
Seyhan, I ;
Ratke, L ;
Bender, W ;
Voorhees, PW .
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1996, 27 (09) :2470-2478
[16]   The development of spatial correlations during Ostwald ripening: A test of theory [J].
Snyder, VA ;
Alkemper, J ;
Voorhees, PW .
ACTA MATERIALIA, 2000, 48 (10) :2689-2701
[17]   ANALYSIS OF PARTICLE GROWTH BY COALESCENCE DURING LIQUID-PHASE SINTERING [J].
TAKAJO, S ;
KAYSSER, WA ;
PETZOW, G .
ACTA METALLURGICA, 1984, 32 (01) :107-113
[18]   Evolution of near-equiaxed microstructure in the semisolid state [J].
Tzimas, E ;
Zavaliangos, A .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2000, 289 (1-2) :228-240
[19]   A comparative characterization of near-equiaxed microstructures as produced by spray casting, magnetohydrodynamic casting and the stress induced, melt activated process [J].
Tzimas, E ;
Zavaliangos, A .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2000, 289 (1-2) :217-227
[20]   Structural evolution of conventional cast dendritic and spray-cast non-dendritic structures during isothermal holding in the semi-solid state [J].
Wang, JL ;
Su, YH ;
Tsao, CYA .
SCRIPTA MATERIALIA, 1997, 37 (12) :2003-2007