共 38 条
Characterization of controlled low-strength material obtained from dewatered sludge and refuse incineration bottom ash: Mechanical and microstructural perspectives
被引:37
作者:
Zhen, Guangyin
[1
,3
]
Lu, Xueqin
[2
,3
]
Zhao, Youcai
[1
]
Niu, Jing
[1
]
Chai, Xiaoli
[1
]
Su, Lianghu
[1
]
Li, Yu-You
[3
,4
]
Liu, Yuan
[3
]
Du, Jingru
[3
]
Hojo, Toshimasa
[3
]
Hu, Yong
[3
]
机构:
[1] Tongji Univ, State Key Lab Pollut Control & Resource Reuse, Sch Environm Sci & Engn, Shanghai 200092, Peoples R China
[2] Shanghai Univ, Sch Environm & Chem Engn, Shanghai 200444, Peoples R China
[3] Tohoku Univ, Grad Sch Environm Studies, Aoba Ku, Sendai, Miyagi 9808579, Japan
[4] Tohoku Univ, Dept Civil & Environm Engn, Grad Sch Engn, Aoba Ku, Sendai, Miyagi 9808579, Japan
基金:
中国国家自然科学基金;
关键词:
Dewatered sludge;
Municipal solid waste incineration bottom;
ash;
Controlled low-strength material;
Unconfined compressive strength;
FLY-ASH;
SEWAGE-SLUDGE;
ETTRINGITE;
MATRIX;
SOLIDIFICATION/STABILIZATION;
STABILIZATION/SOLIDIFICATION;
LEACHABILITY;
TEMPERATURE;
PERFORMANCE;
EXCITATION;
D O I:
10.1016/j.jenvman.2013.07.008
中图分类号:
X [环境科学、安全科学];
学科分类号:
08 ;
0830 ;
摘要:
Potential reuse of dewatered sludge (DS) and municipal solid waste incineration (MSWI) bottom ash as components to develop controlled low-strength material (CLSM) was explored. The effects of DS:MSWI bottom ash:calcium sulfoaluminate (C (S) over barA) cement ratio and thermal treatment of MSWI bottom ash at 900 degrees C on the mechanical and microstructural properties of CLSM were intensively studied to optimize the process. Results showed DS and MSWI bottom ash could be utilized for making CLSM. The CLSM prepared with milled MSWI bottom ash gave higher unconfined compressive strength (UCS) of 2.0-6.2 MPa following 1 year of curing at 1.0:0.1:0.9 <= DS:MSWI bottom ash:C (S) over barA < 1.0:0.8:0.2. However, the corresponding strengths for CLSM containing thermally treated MSWI bottom ash ranged from 0.7 to 4.6 MPa, decreasing 26-65%. The microstructural analysis by X-ray powder diffraction (XRD), Fourier transforms infrared spectroscopy (FT-IR), as well as scanning electron microscopy (SEM) combined with an energy dispersive X-ray spectroscopy (EDS) revealed that ettringite (C(3)A center dot 3C (S) over bar .H-32, or AFt) crystals were the most important strength-producing constituents which grew into and filled the CLSM matrix pores. Milled MSWI bottom ash addition favored the formation of highly crystalline AFt phases and accordingly enhanced compressive strengths of CLSM specimens. In contrast, thermal treatment at 900 degrees C produced new phases such as gehlenite (Ca2Al2SiO7) and hydroxylapatite (Ca-5(PO4)(3)(OH)), which deteriorated the pozzolanic activity of bottom ash and caused the strengths to decrease. Leaching tests evidenced that leachable substances from CLSM samples exhibited negligible health and environmental risks. The results of this study suggested that MSWI bottom ash can be effectively recycled together with DS in developing CLSM mixtures with restricted use of C (S) over barA cement. (C) 2013 Elsevier Ltd. All rights reserved.
引用
收藏
页码:183 / 189
页数:7
相关论文