Mechanical durability of an optimized polymer concrete under various thermal cyclic loadings - An experimental study

Investigating the tensile strength (sigma(t)) and model fracture toughness (K-Ic) of polymer concrete (PC) materials due to their quasi-brittle behavior is of great interest to engineers. In this paper, the mechanical durability of an optimized epoxy PC, focused on the two above properties, are experimentally investigated under three different freeze/thaw cycles. The diametrally compressed un-cracked Brazilian disc (BD) and the single edge notch bending (SENB) test configurations are used to measure the split tensile strength and fracture toughness, respectively. The thermal cycles; 25 degrees C to -30 degrees C (cycle-A), 25 degrees C to 70 degrees C (cycle-B) and -30 degrees C to 70 degrees C (cycle-C) applied for 7 days to the test specimens; are chosen according to the climate of Iran in different seasons. Experimental results show the noticeable influence of thermal cycles, especially cycle-B, on both fracture toughness and tensile strength. Heat-to-cool thermal cycle-A and thawing thermal cycle-B indicate the most increase and reduction, respectively on both at and K-Ic in comparison to ambient conditions. Also, it was shown that the fracture toughness and tensile strength of tested PC materials are reduced by increasing the mean temperature values of thermal cycles. (C) 2014 Elsevier Ltd. All rights reserved.