The study of combustion of municipal waste in a fluidized bed combustor

The combustion behavior of municipal solid waste teas studied in a pilot fluidized bed combustor The waste was pelletized prior to its use. Both co-firing with coal and combustion of waste alone were under taken. The combustion studies were carried out on the pilot installation of INETI. The fluidized bed combustor is square in cross section with each side being 300 mm long. Its height is 5000 mm. There is a second air supply to the freeboard at different heights to deal with high volatile fuels. There was a continuous monitoring of the temperatures in the bed, as well as the composition of the combustion gases. The combustion gases leaving the reactor were let go through the recycling cyclone first to capture most of particulates elutriated out of the combustor There was a second cyclone, which eras employed with the aim of increasing the overall efficiency of collecting solid particles. The gaseous pollutants leaving the stack were sampled under isokinetic conditions for particulate matter: chlorine compounds, and heavy metals. The ash streams were: characterized,for heavy metals. The results obtained were compared with national legislation. The results obtained suggest that (i) the combustion efficiency was very high, (ii) there was an enrichment of ashes with heavy metals in the cyclones compared to the bed material. (iii) in general, the flue gas emissions were below the permited limits, and (iv) for the compliance with the new European directive for stricter emission limits adequate control devices, like: bag filters, should be integrated with refuse derived fuel (RDF) combustion.