Investigation of a novel (GO@CuO.γ-Al2O3) hybrid nanocomposite for solar energy applications

被引:44
作者
El-Shafai, Nagi M. [1 ]
Ji, Rencai [2 ]
Abdelfatah, Mahmoud [3 ]
Hamada, Mohamed A. [4 ]
Kandeal, A. W. [2 ,4 ]
El-Mehasseb, Ibrahim M. [1 ]
El-Shaer, Abdelhamid [3 ]
An, Meng [6 ]
Ramadan, Mohamed S. [5 ]
Sharshir, Swellam W. [4 ]
Ismail, Walid [3 ]
机构
[1] Kafrelsheikh Univ, Fac Sci, Nanotechnol Ctr, Chem Dept, Kafr Al Sheikh 33516, Egypt
[2] Huazhong Univ Sci & Technol, Sch Energy & Power Engn, Wuhan 430074, Peoples R China
[3] Kafrelsheikh Univ, Fac Sci, Phys Dept, Kafr Al Sheikh 33516, Egypt
[4] Kafrelsheikh Univ, Fac Engn, Mech Engn Dept, Kafrelsheikh 33516, Egypt
[5] Alexandria Univ, Fac Sci, Chem Dept, Alexandria, Egypt
[6] Shaanxi Univ Sci & Technol, Coll Mech & Elect Engn, Xian 710021, Peoples R China
基金
中国国家自然科学基金;
关键词
Graphene oxide; Nanofluids; Thermal conductivity; Solar energy applications; ZNO ROD ARRAYS; GRAPHENE OXIDE; THERMAL-CONDUCTIVITY; THIN-FILM; NANOPARTICLES; FABRICATION; PERFORMANCE; ANTIBACTERIAL; CUO; BIOSYNTHESIS;
D O I
10.1016/j.jallcom.2020.157463
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
A novel hybrid nanomaterial (HNM) (GO@CuO.gamma-Al2O3) was manufactured where the thermal and electrical performances were comprehensively appraised investigated. The combination nanomaterial (NM) was achieved through the loading of Graphene oxide nanosheet (GO) with other NMs quantum dots (QDs); namely: Copper oxide (CuO) nanorod, and Aluminum oxide (gamma-Al2O3) nanoparticles (NPs). X-ray diffraction (XRD), transmission electron microscopy (TEM), Scanning electron microscopy (SEM), and Zeta potential were employed to characterize properties of the fabricated nanomaterials. The results confirmed the formation and loading of NM QDs successfully on the GO surface. Different nanofluids were prepared from mono NMs (GO, CuO, and gamma-Al2O3), and hybrid NMs (GO@CuO, GO@gamma-Al2O3, and GO@CuO.gamma-Al2O3) with water as base fluid, aiming to evaluate the thermal conductivity. Different concentrations of the nanofluids (0.0625, 0.125, and 0.2%) were investigated within a temperature range of 20-50 degrees C. For (GO@CuO.gamma-Al2O3), compared to water, maximum enhancement in thermal conductivity (22.56%) was achieved with 0.2% concentration and 50 degrees C. These results indicate that GO@CuO.gamma-Al2O3 as nanofluid is very favorable for solar collector heaters. The current-voltage (I-V) and photoluminescence (PL) measurements were performed to investigate photocurrent generation and the electron-hole pair recombination. The results showed that GO@CuO nanocomposite has more ability to produce photocurrent rather than the other nanocomposites, where the current of GO@CuO nanocomposites is higher than GO@Al2O3 center dot CuO nanocomposite. GO@CuO nanocomposite has the lowest PL intensity, which shows lower charge carrier recombination and higher light harvesting. The I-V and PL results indicate that GO@CuO nanocomposite is a gifted material for solar cell applications. Consequently, GO@Al2O3 center dot CuO and GO@CuO nanocomposites are very promising candidates with higher performance for solar energy applications. (C) 2020 Elsevier B.V. All rights reserved.
引用
收藏
页数:12
相关论文
共 73 条
[1]   Low cost inorganic white light emitting diode based on submicron ZnO rod arrays and electrodeposited Cu2O thin film [J].
Abdelfatah, Mahmoud ;
Ismail, Walid ;
El-Shaer, Abdelhamid .
MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING, 2018, 81 :44-47
[2]   One step to fabricate vertical submicron ZnO rod arrays by hydrothermal method without seed layer for optoelectronic devices [J].
Abdelfatah, Mahmoud ;
El-Shaer, Abdelhamid .
MATERIALS LETTERS, 2018, 210 :366-369
[3]   Effect of Potentiostatic and Galvanostatic Electrodeposition Modes on the Basic Parameters of Solar Cells Based on Cu2O Thin Films [J].
Abdelfatah, Mahmoud ;
Ledig, Johannes ;
El-Shaer, Abdelhamid ;
Sharafeev, Azat ;
Lemmens, Peter ;
Mosaad, Mohsen Mohamed ;
Waag, Andreas ;
Bakin, Andrey .
ECS JOURNAL OF SOLID STATE SCIENCE AND TECHNOLOGY, 2016, 5 (06) :Q183-Q187
[4]   Fabrication and characterization of flexible solar cell from electrodeposited Cu2O thin film on plastic substrate [J].
Abdelfatah, Mahmoud ;
Ledig, Johannes ;
El-Shaer, Abdelhamid ;
Wagner, Alexander ;
Sharafeev, Azat ;
Lemmens, Peter ;
Mosaad, Mohsen Mohamed ;
Waag, Andreas ;
Bakin, Andrey .
SOLAR ENERGY, 2015, 122 :1193-1198
[5]   Fabrication and characterization of low cost Cu2O/ZnO:Al solar cells for sustainable photovoltaics with earth abundant materials [J].
Abdelfatah, Mahmoud ;
Ledig, Johannes ;
El-Shaer, Abdelhamid ;
Wagner, Alexander ;
Marin-Borras, Vicente ;
Sharafeev, Azat ;
Lemmens, Peter ;
Mosaad, Mohsen Mohamed ;
Waag, Andreas ;
Bakin, Andrey .
SOLAR ENERGY MATERIALS AND SOLAR CELLS, 2016, 145 :454-461
[6]   Influence of particle size on the effective thermal conductivity of nanofluids: A critical review [J].
Ambreen, Tehmina ;
Kim, Man-Hoe .
APPLIED ENERGY, 2020, 264 (264)
[7]   Preparation and characteristics evaluation of mono and hybrid nano-enhanced phase change materials (NePCMs) for thermal management of microelectronics [J].
Arshad, Adeel ;
Jabbal, Mark ;
Yan, Yuying .
ENERGY CONVERSION AND MANAGEMENT, 2020, 205
[8]   Synthesis of high-surface-area γ-Al2O3 from aluminum scrap and its use for the adsorption of metals: Pb(II), Cd(II) and Zn(II) [J].
Asencios, Yvan J. O. ;
Sun-Kou, Maria R. .
APPLIED SURFACE SCIENCE, 2012, 258 (24) :10002-10011
[9]   Achievements in mid and high -temperature selective absorber coatings by physical vapor deposition (PVD) for solar thermal Application -A review [J].
Bello, Mutawalli ;
Shanmugan, Subramani .
JOURNAL OF ALLOYS AND COMPOUNDS, 2020, 839
[10]   Conjugate heat transfer in a duct using nanofluid by two-phase Eulerian-Lagrangian method: Effect of non-uniform heating [J].
Borah, Abhijit ;
Boruah, Manash Protim ;
Pati, Sukumar .
POWDER TECHNOLOGY, 2019, 346 :180-192