Morphometry of scoria cones located on a volcano flank: A case study from Mt. Etna (Italy), based on high-resolution LiDAR data

被引:99
|
作者
Favalli, Massimilano [1 ]
Karatson, David [2 ,3 ]
Mazzarini, Francesco [1 ]
Pareschi, Maria Teresa [1 ]
Boschi, Enzo [1 ]
机构
[1] Ist Nazl Geofis & Vulcanol, I-56126 Pisa, Italy
[2] Eotvos Lorand Univ, Dept Phys Geog, H-1117 Budapest, Hungary
[3] Univ Gottingen, Geosci Ctr, D-37077 Gottingen, Germany
关键词
scoria cone; morphometry; Etna; H/W(co) ratio; DEM analysis; MOUNT-ETNA; CINDER CONES; EVOLUTION; ERUPTION; DEGRADATION; MORPHOLOGY; GROWTH; FIELDS; AGE;
D O I
10.1016/j.jvolgeores.2009.07.011
中图分类号
P [天文学、地球科学];
学科分类号
07 ;
摘要
By using new high-resolution (2 m) digital elevation model derived from the 2005 LiDAR survey of Mt. Etna volcano (Italy), our study measured the classical morphometrical parameters for scoria cones, i.e. W(co) (cone width), W(cr) (crater diameter), H (cone height) as well as volume, inclination of cone slope and substrate, and a number of other parameters for 135 scoria cones of Mt. Etna. Volume and age distribution of cones shows that there is no direct structural control on their emplacement in terms of Etna's rift zones. The cones are progressively smaller in size toward summit, which can be explained by the large volcano's feeding system and progressively frequent lava burial toward top. A careful analysis of H/W(co) ratio (determined as 0.18 for other volcanic fields worldwide) shows that this ratio strongly depends on (1) the calculation method of H and (2) lava burial of cone. For Etnean cones, applying an improved method for calculating H relative to the dipping substrate results in a significantly lowered standard H/W(co) ratio (0.137), which in turn questions the validity of the classical value of 0.18 in the case of large central volcanoes. The reduction of the ratio is not only due to methodology but also to the common lava burial. This can be expressed even better if H(mean) is used instead of H(max) (H(mean)/W(co) = 0.098). Using this measure, at Etna, well formed cones have higher ratios than structurally deformed (e. g. double or rifted) cones. Furthermore, although the sampled scoria cones at Etna have formed in a relatively narrow time interval (<6500 yrs BP), there is a slight decrease in H/W(co) corresponding to erosional changes detected globally (H/W(co) = 0.143, 0.135 and 0.115 for three age classes of Etna's scoria cones, corresponding to average slopes of 26.6, 23.9 and 23.7 degrees). Because the morphometrical effect of position on a dipping substrate as well as lava burial exceeds the effect of erosion, we call attention to use caution in simply using the H/W(co) ratio of scoria cones for detecting age, especially on large active volcanoes. (C) 2009 Elsevier B.V. All rights reserved.
引用
收藏
页码:320 / 330
页数:11
相关论文
共 50 条
  • [1] Mt. Etna volcano high-resolution topography: airborne LiDAR modelling validated by GPS data
    Bisson, Marina
    Spinetti, Claudia
    Neri, Marco
    Bonforte, Alessandro
    INTERNATIONAL JOURNAL OF DIGITAL EARTH, 2016, 9 (07) : 710 - 732
  • [2] Scoria cones on Mars: Detailed investigation of morphometry based on high-resolution digital elevation models
    Broz, Petr
    Cadek, Ondrej
    Hauber, Ernst
    Rossi, Angelo Pio
    JOURNAL OF GEOPHYSICAL RESEARCH-PLANETS, 2015, 120 (09) : 1512 - 1527
  • [3] The unstable eastern flank of Mt. Etna volcano (Italy): First results of a GNSS-based network at its southeastern edge
    De Guidi, Giorgio
    Brighenti, Fabio
    Carnemolla, Francesco
    Imposa, Sebastiano
    Marchese, Salvatore Antonio
    Palano, Mimmo
    Scudero, Salvatore
    Vecchio, Alessia
    JOURNAL OF VOLCANOLOGY AND GEOTHERMAL RESEARCH, 2018, 357 : 418 - 424
  • [4] First application of ASDP software:: a case study at Mt. Etna volcano and in the Acri region (Southern Italy)
    Patanè, D
    Ferrari, F
    Ferrucci, F
    PHYSICS OF THE EARTH AND PLANETARY INTERIORS, 1999, 113 (1-4) : 75 - 88
  • [5] Exploratory seismic site response surveys in a complex geologic area: a case study from Mt. Etna volcano (southern Italy)
    Panzera, F.
    Lombardo, G.
    Longo, E.
    Langer, H.
    Branca, S.
    Azzaro, R.
    Cicala, V.
    Trimarchi, F.
    NATURAL HAZARDS, 2017, 86 : S385 - S399
  • [6] Exploratory seismic site response surveys in a complex geologic area: a case study from Mt. Etna volcano (southern Italy)
    F. Panzera
    G. Lombardo
    E. Longo
    H. Langer
    S. Branca
    R. Azzaro
    V. Cicala
    F. Trimarchi
    Natural Hazards, 2017, 86 : 385 - 399
  • [7] Cooling history of a dike as revealed by mineral chemistry: A case study from Mt. Etna volcano
    Mollo, Silvio
    Lanzafame, Gabriele
    Masotta, Matteo
    Iezzi, Gianluca
    Ferlito, Carmelo
    Scarlato, Piergiorgio
    CHEMICAL GEOLOGY, 2011, 288 (1-2) : 39 - 52
  • [8] Evidence of multiple strain fields beneath the eastern flank of Mt. Etna volcano (Sicily, Italy) deduced from seismic and geodetic data during 2003–2004
    Salvatore Alparone
    Graziella Barberi
    Alessandro Bonforte
    Vincenza Maiolino
    Andrea Ursino
    Bulletin of Volcanology, 2011, 73 : 869 - 885
  • [9] Evidence of multiple strain fields beneath the eastern flank of Mt. Etna volcano (Sicily, Italy) deduced from seismic and geodetic data during 2003-2004
    Alparone, Salvatore
    Barberi, Graziella
    Bonforte, Alessandro
    Maiolino, Vincenza
    Ursino, Andrea
    BULLETIN OF VOLCANOLOGY, 2011, 73 (07) : 869 - 885
  • [10] TROPOMI enables high resolution SO2 flux observations from Mt. Etna, Italy, and beyond
    Queisser, Manuel
    Burton, Mike
    Theys, Nicolas
    Pardini, Federica
    Salerno, Giuseppe
    Caltabiano, Tommaso
    Varnam, Matthew
    Esse, Benjamin
    Kazahaya, Ryunosuke
    SCIENTIFIC REPORTS, 2019, 9 (1)