Investigation of long-term engine oil performance using lab-based artificial ageing illustrated by the impact of ethanol as fuel component

被引:36
作者
Besser, Charlotte [1 ]
Schneidhofer, Christoph [1 ]
Doerr, Nicole [1 ]
Novotny-Farkas, Franz [2 ]
Allmaier, Guenter [3 ]
机构
[1] AC2T Res GmbH, Austrian Ctr Competence Tribol, A-2700 Wiener Neustadt, Austria
[2] OMV Refining & Mkt GmbH, Vienna, Austria
[3] Vienna Univ Technol, Inst Chem Technol & Analyt, A-1040 Vienna, Austria
关键词
Lubrication oil; Chemical degradation; Oxidative degradation; Condition monitoring; EMISSIONS;
D O I
10.1016/j.triboint.2011.06.026
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
The effect of ethanol and its combustion products on the lubrication system is not very well understood. In this paper, a novel lab-based artificial ageing method for the evaluation of engine oils for bio-fuelled automotives and the results thereof are presented. Artificial ageing of three fully formulated engine oils with addition of ethanol, acetaldehyde, and acetic acid was carried out. The oil formulations chosen represent a consequent series of optimisation steps based on the engine oil performance in terms of preservation of typical oil parameters. e.g. base reserve and oxidation, observed during the artificial ageing procedure. It was shown that ethanol as well as acetaldehyde has almost no effect on the oil degradation especially in the case that advanced additive technology was used. On the contrary, acetic acid significantly affected the formulated oil showing influence on the detergent chemistry and even caused sludge formation. The use of the novel artificial ageing method proved to clearly differentiate the impact of the respective compounds added with the possibility to simulate enhanced stress conditions without the need of time-consuming and expensive engine bench tests. Hence, the novel setup offers valuable input for the formulation and the pre-selection of future engine oils suitable for bio-fuel. (C) 2011 Elsevier Ltd. All rights reserved.
引用
收藏
页码:174 / 182
页数:9
相关论文
共 28 条
[1]  
[Anonymous], 2009, D707909 ASTM INT
[2]  
[Anonymous], 2008320019 SAE INT
[3]  
[Anonymous], 1985, 51352 DIN
[4]  
[Anonymous], 2008, D659408 ASTM INT
[5]  
[Anonymous], 1979, 51558 DIN
[6]  
[Anonymous], 2009, D633509 ASTM INT
[7]  
[Anonymous], 51453 DIN
[8]  
[Anonymous], 2008, D474208E1 ASTM INT
[9]  
[Anonymous], 2008011763 SAE INT
[10]  
[Anonymous], 1978, 51554 DIN