Internal curing of engineered cementitious composites for prevention of early age autogenous shrinkage cracking

被引:206
作者
Sahmaran, Mustafa [2 ]
Lachemi, Mohamed [1 ]
Hossain, Khandaker M. A. [1 ]
Li, Victor C. [3 ]
机构
[1] Ryerson Univ, Dept Civil Engn, Toronto, ON, Canada
[2] Gaziantep Univ, Dept Civil Engn, Gaziantep, Turkey
[3] Univ Michigan, Dept Civil & Environm Engn, Ann Arbor, MI 48109 USA
基金
美国国家科学基金会; 加拿大自然科学与工程研究理事会;
关键词
Autogenous shrinkage; Drying shrinkage; Engineered cementitious composites (ECC); internal curing; Uniaxial tensile test; Flexural test; HIGH-STRENGTH CONCRETE; RHEOLOGICAL CONTROL; VOLUME; PERFORMANCE;
D O I
10.1016/j.cemconres.2009.07.006
中图分类号
TU [建筑科学];
学科分类号
0813 ;
摘要
This investigation was carried out to study the effects of using a replacement percentage of saturated lightweight fine aggregate (LWA) as an internal curing agent on the shrinkage and mechanical behavior of Engineered Cementitious Composites (ECC). ECC is a micromechanically-based, designed high-performance, fiber-reinforced cementitious composite with high ductility and improved durability due to tight crack width. Standard ECC mixtures are typically produced with micro-silica sand (200 pm maximum aggregate size). Two replacement levels of silica sand with saturated LWA (fraction 0.59-4.76 mm) were adopted: the investigation used 10 and 20% by weight of total silica sand content, respectively. For each LWA replacement level, two different ECC mixtures with a fly ash-to-Portland cement ratio (FA/PC) of 1.2 and 2.2 were cast. In a control test series, two types of standard ECC mixtures with only silica sand were also studied. To investigate the effect of replacing a portion of the silica sand with saturated LWA on the mechanical properties of ECC, the study compared the results of uniaxial tensile, flexure and compressive strength tests, crack development, autogenous shrinkage and drying shrinkage. The test results showed that the autogenous shrinkage strains of the control ECCs with a low water-to-cementitious material ratio (W/CM) (0.27) and high volume FA developed rapidly, even at early ages. The results also showed that up to a 20% replacement of normal-weight silica sand with saturated LWA was very effective in reducing the autogenous shrinkage and drying shrinkage of ECC. On the other hand, the partial replacement of silica sand with saturated LWA with a nominal maximum aggregate size of 4.76 mm is shown to have a negative effect, especially on the ductility and strength properties of ECC. The test results also confirm that the autogenous shrinkage and drying shrinkage of ECC significantly decreases with increasing FA content. Moreover, increasing FA content is shown to have a positive effect on the ductility of ECC. (C) 2009 Elsevier Ltd. All rights reserved.
引用
收藏
页码:893 / 901
页数:9
相关论文
共 41 条
[1]   Optimisation of using lightweight aggregates in mitigating autogenous deformation of concrete [J].
Akcay, Burcu ;
Tasdemir, Mehmet Ali .
CONSTRUCTION AND BUILDING MATERIALS, 2009, 23 (01) :353-363
[2]   Prevention of autogenous shrinkage in high-strength concrete by internal curing using wet lightweight aggregates [J].
Bentur, A ;
Igarashi, S ;
Kovler, K .
CEMENT AND CONCRETE RESEARCH, 2001, 31 (11) :1587-1591
[3]   Early-age properties of cement-based materials. I: Influence of cement fineness [J].
Bentz, Dale P. ;
Sant, Gaurav ;
Weiss, Jason .
JOURNAL OF MATERIALS IN CIVIL ENGINEERING, 2008, 20 (07) :502-508
[4]  
Bentz DP, 2007, ACI MATER J, V104, P408
[5]   Protected paste volume in concrete - Extension to internal curing using saturated lightweight fine aggregate [J].
Bentz, DP ;
Snyder, KA .
CEMENT AND CONCRETE RESEARCH, 1999, 29 (11) :1863-1867
[6]   Influence of cement particle-size distribution on early age autogenous strains and stresses in cement-based materials [J].
Bentz, DP ;
Jensen, OM ;
Hansen, KK ;
Olesen, JF ;
Stang, H ;
Haecker, CJ .
JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 2001, 84 (01) :129-135
[7]  
BISAILLON A, 1994, ACI MATER J, V91, P178
[8]  
Cusson D., 2008, Internal Curing of High-Performance Concretes: Laboratory and Field Experiences, SP-256 pp, P105
[9]  
Durán-Herrera A, 2007, ACI MATER J, V104, P48
[10]  
Edvardsen C, 1999, ACI MATER J, V96, P448