Effects of the sintering temperature on the oxygen adsorption in ZnO ceramics

被引:19
|
作者
Castro, MS [1 ]
Aldao, CM [1 ]
机构
[1] Univ Mar del Plata, Inst Mat Sci & Technol, CONICET, INTEMA, RA-7600 Mar Del Plata, Argentina
关键词
sintering; grain boundaries; electrical conductivity; ZnO; sensors;
D O I
10.1016/S0955-2219(98)00210-6
中图分类号
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
Changes in electrical resistivity due to oxygen adsorption for samples prepared at different sintering temperature are presented. It was found that samples cooled in steps from the sintering temperature show a higher resistivity and that oxygen indiffusion is faster in quenched samples and in samples sintered at low temperatures. Two mechanisms were determined to be responsible for an increase in the sample resistivity. First, oxygen adsorption at grains surfaces produces a rapid increase in resistivity and then a slow change in the response due to oxygen diffusion into the grains. (C) 1999 Elsevier Science Limited. All rights reserved.
引用
收藏
页码:511 / 515
页数:5
相关论文
共 50 条
  • [21] Thermoelectric properties of ZnO ceramics densified through spark plasma sintering
    Radingoana, P. M.
    Guillemet-Fritsch, S.
    Noudem, J.
    Olubambi, P. A.
    Chevallier, G.
    Estournes, C.
    CERAMICS INTERNATIONAL, 2020, 46 (04) : 5229 - 5238
  • [22] Cold sintering process of ZnO ceramics: Effect of the nanoparticle/microparticle ratio
    Serrano, Aida
    Caballero-Calero, Olga
    Garcia, Miguel Angel
    Lazic, Snezana
    Carmona, Noemi
    Castro, German R.
    Martin-Gonzalez, Marisol
    Fernandez, Jose F.
    JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2020, 40 (15) : 5535 - 5542
  • [23] Synthesis and characterization of ZnO based varistor ceramics: effect of sintering temperatures
    Bouchekhlal, Ahmed
    Boulesbaa, Mohammed
    MICROELECTRONICS INTERNATIONAL, 2022, 39 (03) : 110 - 120
  • [24] Low temperature sintering of fluorapatite glass-ceramics
    Denry, Isabelle
    Holloway, Julie A.
    DENTAL MATERIALS, 2014, 30 (02) : 112 - 121
  • [25] Microstructure and Varistor Properties of ZVMND Ceramics with Sintering Temperature
    Nahm, Choon-Woo
    TRANSACTIONS ON ELECTRICAL AND ELECTRONIC MATERIALS, 2015, 16 (04) : 221 - 225
  • [26] The influence of sintering temperature on the engineered nanoporous titania ceramics
    Mahmoud, Waleed E.
    Al-Agel, F. A.
    Al-Arfaj, E. A.
    MATERIALS LETTERS, 2013, 96 : 146 - 148
  • [27] Effect of oxygen sintering on the structural and electrical properties of KNN ceramics
    Palei, P.
    Pattanaik, M.
    Kumar, P.
    CERAMICS INTERNATIONAL, 2012, 38 (01) : 851 - 854
  • [28] Effect of sintering temperature on the structural, morphological and humidity sensing properties of ZnO nanostructure
    Zaidi, A.
    Tiwari, K.
    Awasthi, R. R.
    Dubey, K. C.
    JOURNAL OF OVONIC RESEARCH, 2023, 19 (04): : 411 - 419
  • [29] Effects of alumina sols on the sintering of α-alumina ceramics
    Yang, Rui
    Qi, Zhe
    Gao, Ye
    Yang, Jinhua
    Zhou, Yiran
    Liu, Hu
    Peng, Luming
    Jiao, Jian
    CERAMICS INTERNATIONAL, 2020, 46 (13) : 20865 - 20870
  • [30] Influence of the sintering temperature on the electrical and luminescent properties of Mn-doped ZnO
    Ronfard-Haret, JC
    SOLID STATE IONICS, 2004, 167 (3-4) : 355 - 366