Influence of Co content on stacking fault energy in Ni-Co base disk superalloys

被引:125
作者
Yuan, Yong [1 ]
Gu, Yuefeng [1 ]
Cui, Chuanyong [1 ]
Osada, Toshio [1 ]
Zhong, Zhihong [1 ]
Tetsui, Toshimitsu [1 ]
Yokokawa, Tadaharu [1 ]
Harada, Hiroshi [1 ]
机构
[1] Natl Inst Mat Sci, High Temp Mat Ctr, Tsukuba, Ibaraki 3050047, Japan
关键词
DEFORMATION; ALLOYS; METALS; STRESS; COPPER; CREEP;
D O I
10.1557/jmr.2011.346
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The influence of Co content on stacking fault energy (SFE) of the gamma matrix in four Ni-Co base superalloys, including newly developed alloys, has been studied by utilizing high-resolution transmission electron microscopy. The results indicated the SFE was not linear with Co content of the gamma matrix. The lowest SFE could be attained at around 34.0 at.% Co. This effect was attributed to variation of electron holes, saturated Co content in the matrix, and the effect of Co on the partition coefficient of other alloying elements. A high density of twins was related to low SFE and could improve the mechanical properties.
引用
收藏
页码:2833 / 2837
页数:5
相关论文
共 28 条
[1]   STACKING FAULT ENERGY IN SILICON [J].
AERTS, E ;
SIEMS, R ;
DELAVIGNETTE, P ;
AMELINCKX, S .
JOURNAL OF APPLIED PHYSICS, 1962, 33 (10) :3078-&
[2]   High strength and utilizable ductility of bulk ultrafine-grained Cu-Al alloys [J].
An, X. H. ;
Han, W. Z. ;
Huang, C. X. ;
Zhang, P. ;
Yang, G. ;
Wu, S. D. ;
Zhang, Z. F. .
APPLIED PHYSICS LETTERS, 2008, 92 (20)
[3]   MODIFIED SYSTEM FOR PREDICTING SIGMA FORMATION [J].
BARROWS, RG ;
NEWKIRK, JB .
METALLURGICAL TRANSACTIONS, 1972, 3 (11) :2889-&
[4]   LOW-TEMPERATURE DEFORMATION OF COPPER SINGLE CRYSTALS [J].
BLEWITT, TH ;
COLTMAN, RR ;
REDMAN, JK .
JOURNAL OF APPLIED PHYSICS, 1957, 28 (06) :651-660
[5]   Phase constituents and compressive yield stress of Ni-Co base alloys [J].
Cui, C. Y. ;
Gu, Y. F. ;
Ping, D. H. ;
Fukuda, T. ;
Harada, H. .
MATERIALS TRANSACTIONS, 2008, 49 (03) :424-427
[6]  
Cui CY, 2005, METALL MATER TRANS A, V36A, P2921
[7]   Effect of stacking fault energy on plastic deformation of nanocrystalline face-centered cubic metals [J].
Ebrahimi, F ;
Ahmed, Z ;
Li, H .
APPLIED PHYSICS LETTERS, 2004, 85 (17) :3749-3751
[8]   A transparent indenter measurement method for mechanical property evaluation [J].
Feng, C ;
Kang, BSJ .
EXPERIMENTAL MECHANICS, 2006, 46 (01) :91-103
[9]   DEFORMATION TWINNING IN AL-4.8 WT-PERCENT MG [J].
GRAY, GT .
ACTA METALLURGICA, 1988, 36 (07) :1745-1754
[10]   Comparison of Mechanical Properties of TMW Alloys, New Generation of Cast-and-Wrought Superalloys for Disk Applications [J].
Gu, Y. F. ;
Fukuda, T. ;
Cui, C. ;
Harada, H. ;
Mitsuhashi, A. ;
Yokokawa, T. ;
Fujioka, J. ;
Koizumi, Y. ;
Kobayashi, T. .
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2009, 40A (13) :3047-3050