Effect of Quartz Replacement with Palm Oil Fuel Ash (POFA) for Triaxial Porcelain Composition of 50%: 40%: 10%

被引：0

作者：

Durumin-Iya, Sani Garba ^{[1
]}

Noh, Mohamad Zaky ^{[2
]}

Hanafiah, Siti Raledah Binti Mohd ^{[2
]}

Radzi, Siti Fairuz Binti Mat ^{[2
]}

Adamu, Maryam Sunusi ^{[2
]}

机构：

[1] Sule Lamido Univ Kafin Hausa, Fac Nat & Appl Sci, Dept Phys, Kafin Hausa 048, Jigawa State, Nigeria

[2] Univ Tun Hussein Onn Malaysia, Fac Appl Sci & Technol, Dept Phys & Chem, Muar 84600, Johor, Malaysia

来源：

INTERNATIONAL JOURNAL OF NANOELECTRONICS AND MATERIALS | 2022年 / 15卷 / 01期

关键词：

Porcelain; Quartz; POFA; Feldspar; Clay; SUBSTITUTION; STRENGTH;

D O I：

暂无

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Palm oil fuel ash (POFA) is a waste material disposed by the palm oil industries after palm oil shell, kernel and fiber are burnt in the industries for the process of electricity generation. Triaxial porcelain (50% clay, 40% feldspar and quartz 10%) was adopted for this research. Quartz was progressively replaced with POFA at 0%, 20%, 40%, 60%, 80% and 100% respectively. The samples were dry pressed and 91 MPa was used as a mould pressure with different sintering temperatures of 100 degrees C, 1150 degrees C and 1200 degrees C respectively. The result shows that, samples containing POFA yield higher mass loss and volume shrinkage at all the sintering temperature range. Meanwhile, lower densities were reported when quartz is replaced with POFA at 100% for the entire temperature range. The maximum compressive strength (125.42 MPA) was obtained at sintering temperature of 1100 degrees C for 100% replacement of quartz with POFA. XRD studies revealed higher mullitization in the samples containing palm oil fuel ash.

引用

页码：71 / 78

页数：8

共 13 条

[1] Betala S. K., 2018, EFFECT REPLACEMENT Q
[2] Effect of substitution of fly ash for quartz in triaxial kaolin-quartz-feldspar system
Dana, K
Das, S
Das, SK
[J]. JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2004, 24 (10-11) : 3169 - 3175
[3] Influence of composition on mechanical behaviour of porcelain tile. Part I: Microstructural characterization and developed phases after firing
De Noni, Agenor, Jr.
Hotza, Dachamir
Cantavella Soler, Vicente
Sanchez Vilches, Enrique
[J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2010, 527 (7-8): : 1730 - 1735
[4] Effect of Palm Oil Fuel Ash Treatment on Physico-Mechanical Properties of Porcelain
Iya, Sani Garba Durumin
Noh, Mohamad Zaky
Kutty, Nur Azureen Alwi
Ab Razak, Siti Noraiza
Warikh, A. R. M.
Mohamed, Julie Juliewatty
Nor, Mohd Al Amin Muhamad
[J]. MATERIALS CHARACTERIZATION USING X-RAYS AND RELATED TECHNIQUES, 2019, 2068
[5] Iya Sani Garba Durumin, 2019, J FDN APPL PHYS, V6
[6] Jamo H. U., 2014, Science World Journal, V9, P23
[7] Palm oil fuel ash as potential green micro-filler in polymer concrete
Khalid, Nur Hafizah A.
Hussin, Mohd W.
Mirza, Jahangir
Ariffin, Nur Farhayu
Ismail, Mohamed A.
Lee, Han-Seung
Mohamed, Azman
Jaya, Ramadhansyah Putra
[J]. CONSTRUCTION AND BUILDING MATERIALS, 2016, 102 : 950 - 960
[8] On blended cement and geopolymer concretes containing palm oil fuel ash
Khankhaje, Elnaz
Hussin, Mohd Warid
Mirza, Jahangir
Rafieizonooz, Mandi
Salim, Mohd Razman
Siong, Ho Chin
Warid, Muhammad Naqiuddin Mohd
[J]. MATERIALS & DESIGN, 2016, 89 : 385 - 398
[9] Mullite formation in clays and clay-derived vitreous ceramics
Lee, W. E.
Souza, G. P.
McConville, C. J.
Tarvornpanich, T.
Iqbal, Y.
[J]. JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2008, 28 (02) : 465 - 471
[10] MANFREDINI T, 1995, AM CERAM SOC BULL, V74, P76

← 1 2 →