Radio frequency sputter deposition of Cu2ZnSnS4 thin films with a temperature-controlled reflector wall: Effects of H2 addition to the sputtering gas

被引:1
作者
Kusano, Eiji [1 ]
Kondo, Yu [1 ]
机构
[1] Kanazawa Inst Technol, Adv Mat Sci Ctr, Haku San, Ishikawa 9240838, Japan
关键词
Copper zinc tin sulfide; Thin films; Sputtering; Reflector wall; Hydrogen discharge gas; PULSED-LASER DEPOSITION; SINGLE-STEP PREPARATION; BAND-GAP; OPTICAL-PROPERTIES; SOLAR-CELLS; OXYGEN CONTAMINATION; FLASH EVAPORATION; VEGARDS LAW; SULFURIZATION; FABRICATION;
D O I
10.1016/j.tsf.2017.11.033
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Cu2ZnSnS4 (CZTS) thin films were deposited from a quaternary ceramic compound target using radio-frequency magnetron sputtering in Ar and Ar-10% H-2 to investigate the effects of H-2 addition to Ar on the film structure and optical and electrical properties. The sputter-deposition system was equipped with a cylindrical reflector wall between the target and substrate to enhance the probability of reimpingement of Zn and S atoms re-evaporated from the growing thin-film surface to the film surface. The thin films deposited in both Ar and Ar-10% H-2 were identified as kesterite Cu2ZnSnS4 with < 112 > preferred orientation by X-ray diffraction measurements and Raman spectroscopy. The crystallite size evaluated from the half width at full-maximum of the < 112 > diffraction peak increased from 10 to 12 to 24 nm with the H-2 addition to Ar at substrate temperatures < 200 degrees C. The lattice spacing of (112) also increased by 2-3 nm with the H-2 addition to Ar. Cross-sectional scanning electron microscopy images of the thin films revealed that the thin-film structure changed from a fine to coarse columnar structure with the H-2 addition to Ar. X-ray photoelectron spectroscopy analysis indicated that the O content decreased, whereas the Cu content increased with the H-2 addition. The band gap range of the CZTS thin films deposited in Ar-10% H-2 was 1.4-1.5 eV, which was narrower than that of the films deposited using Ar. The Hall mobility and carrier density were not greatly affected by the H-2 addition to Ar. Although other factors than O content, such as cation ratio, cation/anion ratio, and film crystallinity affect band gap and other film properties, from the fact that the H-2 addition affected the lattice spacing and the band gap clearly, it was concluded that suppression of the incorporation of oxygen into CZTS thin films by the H-2 addition to Ar was the foremost factor for the decrease in the lattice spacing and the narrowing of the band gap.
引用
收藏
页码:75 / 82
页数:8
相关论文
共 50 条
[31]   Influence of carrier gas pressure on the characteristics of nebulizer-sprayed Cu2ZnSnS4 absorber thin films [J].
Gunavathy, K., V ;
Arulanantham, A. M. S. ;
Tamilarasan, K. ;
Rangasami, C. ;
Malathi, M. ;
Shkir, Mohd ;
AlFaify, S. .
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS, 2021, 32 (20) :25493-25506
[32]   Temperature dependent conductivity of polycrystalline Cu2ZnSnS4 thin films [J].
Kosyak, V. ;
Karmarkar, M. A. ;
Scarpulla, M. A. .
APPLIED PHYSICS LETTERS, 2012, 100 (26)
[33]   Close spaced vapor transport deposition of Cu2ZnSnS4 thin films: Effect of iodine pressure [J].
Sagna, A. ;
Djessas, K. ;
Sene, C. ;
Medjnoun, K. ;
Grillo, S. E. .
JOURNAL OF ALLOYS AND COMPOUNDS, 2016, 685 :699-704
[34]   Vibrational studies on Cu2ZnSnS4 thin films prepared by single step reactive DC magnetron sputtering [J].
Kaushik, Deepak Kumar ;
Subrahmanyam, A. .
MATERIALS LETTERS, 2020, 281
[35]   Effects of sulfurization temperature on phases and opto-electrical properties of Cu2ZnSnS4 films prepared by sol-gel deposition [J].
Long, Bo ;
Cheng, Shuying ;
Lai, Yunfeng ;
Zhou, Haifang ;
Yu, Jinling ;
Zheng, Qiao .
THIN SOLID FILMS, 2014, 573 :117-121
[36]   Effects of Sputter Deposition Sequence and Sulfurization Process of Cu, Zn, Sn on Properties of Cu2ZnSnS4 Solar Cell Material [J].
Park, Nam-Kyu ;
Arepalli, Vinaya Kumar ;
Kim, Eui-Tae .
KOREAN JOURNAL OF MATERIALS RESEARCH, 2013, 23 (06) :304-308
[37]   The Effects of Substrate Temperature on the Properties of Kesterite Cu2ZnSnS4 Thin Films Deposited Using a Single Quaternary Target [J].
Yoo, Dongjun ;
Choi, Moon Suk ;
Lim, Donghwan ;
Choi, Changhwan .
NANOSCIENCE AND NANOTECHNOLOGY LETTERS, 2017, 9 (04) :537-543
[38]   Investigation of Cu2ZnSnS4 thin film with preannealing process and ZnS buffer layer prepared by magnetron sputtering deposition [J].
Liu, Wei-Sheng ;
Huang, Chien-Sheng ;
Chen, Shih-Yuan ;
Lee, Ming-Yuan ;
Kuo, Hsing-Chun .
JOURNAL OF ALLOYS AND COMPOUNDS, 2021, 884
[39]   Effect of Sulfurization Temperature on Solution-Processed Cu2ZnSnS4 Thin Films [J].
Park, Si-Nae ;
Sung, Shi-Joon ;
Son, Dae-Ho ;
Kim, Dae-Hwan ;
Sim, Jun-Hyoung ;
Kang, Jin-Kyu .
JOURNAL OF NANOSCIENCE AND NANOTECHNOLOGY, 2015, 15 (03) :2486-2489
[40]   Preparation of Cu2ZnSnS4 thin films via electrochemical deposition and rapid thermal annealing [J].
Lee, Kee Doo ;
Seo, Se-Won ;
Lee, Doh-Kwon ;
Kim, Honggon ;
Jeong, Jeung-Hyun ;
Ko, Min Jae ;
Kim, BongSoo ;
Kim, Dong Hwan ;
Kim, Jin Young .
THIN SOLID FILMS, 2013, 546 :294-298