Radio frequency sputter deposition of Cu2ZnSnS4 thin films with a temperature-controlled reflector wall: Effects of H2 addition to the sputtering gas

被引:1
|
作者
Kusano, Eiji [1 ]
Kondo, Yu [1 ]
机构
[1] Kanazawa Inst Technol, Adv Mat Sci Ctr, Haku San, Ishikawa 9240838, Japan
关键词
Copper zinc tin sulfide; Thin films; Sputtering; Reflector wall; Hydrogen discharge gas; PULSED-LASER DEPOSITION; SINGLE-STEP PREPARATION; BAND-GAP; OPTICAL-PROPERTIES; SOLAR-CELLS; OXYGEN CONTAMINATION; FLASH EVAPORATION; VEGARDS LAW; SULFURIZATION; FABRICATION;
D O I
10.1016/j.tsf.2017.11.033
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Cu2ZnSnS4 (CZTS) thin films were deposited from a quaternary ceramic compound target using radio-frequency magnetron sputtering in Ar and Ar-10% H-2 to investigate the effects of H-2 addition to Ar on the film structure and optical and electrical properties. The sputter-deposition system was equipped with a cylindrical reflector wall between the target and substrate to enhance the probability of reimpingement of Zn and S atoms re-evaporated from the growing thin-film surface to the film surface. The thin films deposited in both Ar and Ar-10% H-2 were identified as kesterite Cu2ZnSnS4 with < 112 > preferred orientation by X-ray diffraction measurements and Raman spectroscopy. The crystallite size evaluated from the half width at full-maximum of the < 112 > diffraction peak increased from 10 to 12 to 24 nm with the H-2 addition to Ar at substrate temperatures < 200 degrees C. The lattice spacing of (112) also increased by 2-3 nm with the H-2 addition to Ar. Cross-sectional scanning electron microscopy images of the thin films revealed that the thin-film structure changed from a fine to coarse columnar structure with the H-2 addition to Ar. X-ray photoelectron spectroscopy analysis indicated that the O content decreased, whereas the Cu content increased with the H-2 addition. The band gap range of the CZTS thin films deposited in Ar-10% H-2 was 1.4-1.5 eV, which was narrower than that of the films deposited using Ar. The Hall mobility and carrier density were not greatly affected by the H-2 addition to Ar. Although other factors than O content, such as cation ratio, cation/anion ratio, and film crystallinity affect band gap and other film properties, from the fact that the H-2 addition affected the lattice spacing and the band gap clearly, it was concluded that suppression of the incorporation of oxygen into CZTS thin films by the H-2 addition to Ar was the foremost factor for the decrease in the lattice spacing and the narrowing of the band gap.
引用
收藏
页码:75 / 82
页数:8
相关论文
共 50 条
  • [1] Control of composition and properties by the use of reflector wall in RF sputter deposition of Cu2ZnSnS4 thin films
    Kusano, Eiji
    Sakamoto, Mune-aki
    THIN SOLID FILMS, 2015, 589 : 433 - 440
  • [2] The chemical vapor deposition of Cu2ZnSnS4 thin films
    Ramasamy, Karthik
    Malik, Mohammad A.
    O'Brien, Paul
    CHEMICAL SCIENCE, 2011, 2 (06) : 1170 - 1172
  • [3] Effects of substrate temperature on the Cu2ZnSnS4 films deposited by radio-frequency sputtering with single target
    Jheng, Bao-Tang
    Huang, Kuo-Min
    Chen, Shang-Fu
    Wu, Meng-Chyi
    THIN SOLID FILMS, 2014, 564 : 345 - 350
  • [4] Deposition of Cu2ZnSnS4 Thin Films by Magnetron Sputtering and Subsequent Sulphurization
    Khalkar, Arun
    Lim, Kwang-Soo
    Yu, Seong-Man
    Patole, Shashikant P.
    Yoo, Ji-Beom
    ELECTRONIC MATERIALS LETTERS, 2014, 10 (01) : 43 - 49
  • [5] Effect of deposition temperature on the properties of Cu2ZnSnS4 (CZTS) thin films
    Khalate, S. A.
    Kate, R. S.
    Kim, J. H.
    Pawar, S. M.
    Deokate, R. J.
    SUPERLATTICES AND MICROSTRUCTURES, 2017, 103 : 335 - 342
  • [6] Spray deposition of Cu2ZnSnS4 thin films
    Valdes, M.
    Santoro, G.
    Vazquez, M.
    JOURNAL OF ALLOYS AND COMPOUNDS, 2014, 585 : 776 - 782
  • [7] Preparation of Cu2ZnSnS4 thin films by hybrid sputtering
    Tanaka, T
    Nagatomo, T
    Kawasaki, D
    Nishio, M
    Guo, QX
    Wakahara, A
    Yoshida, A
    Ogawa, H
    JOURNAL OF PHYSICS AND CHEMISTRY OF SOLIDS, 2005, 66 (11) : 1978 - 1981
  • [8] Fabrication and characterization of Cu2ZnSnS4 thin films by sputtering a single target at different temperature
    Zhao, Qichen
    Hao, Ruiting
    Liu, Sijia
    Yang, Min
    Liu, Xinxing
    Chang, Faran
    Lu, Yilei
    Wang, Shurong
    PHYSICA B-CONDENSED MATTER, 2017, 523 : 62 - 66
  • [9] Sulfurization temperature effects on the growth of Cu2ZnSnS4 thin film
    Yoo, Hyesun
    Kim, JunHo
    Zhang, Lixin
    CURRENT APPLIED PHYSICS, 2012, 12 (04) : 1052 - 1057
  • [10] The Influence of Cycle Sputtering Deposition on the Properties of Cu2ZnSnS4 Thin Films
    Sun, Y. M.
    Yao, B.
    Long, D.
    Meng, X. C.
    Liu, L. H.
    Hua, Z.
    ACTA PHYSICA POLONICA A, 2016, 129 (06) : 1169 - 1172