Thermal-hydraulic analysis of VVER-1000 residual heat removal system using RELAP5 code, an evaluation at the boundary of reactor repair mode

Removing the residual heat from a nuclear reactor is an important safety aspect of thermal hydraulic analysis. In this study, a typical VVER-1000 reactor residual heat removal system has been evaluated using RELAP5 thermal hydraulic loop code during cool-down. Reactor cooling down starts from hot state temperature and then continues to the cool-down stages with 130 degrees C and 70 degrees C, respectively. The second stage of cooling down is the boundary of the reactor repair condition. Main cooling pump head, steam generator (SG) water level, system pressure, the level of coolant in the pressurizer (PRZ), and the temperature of fuel element are examined in a steady state condition. PRZ level, primary circuit and secondary circuit pressure/temperature, and SG water level are evaluated during 32,000 s after cool-down scenario. By comparison, it concluded that the results of RELAP5 code are in agreement with plant experimental data and final safety analysis report (FSAR). Thus, it is proved that the studied reactor is capable to remove the residual heat generated during shutdown. Moreover, RELAP5 is properly recommended for analysis of the VVER-1000 pressurized water reactor during cool-down. (C) 2017 Faculty of Engineering, Alexandria University. Production and hosting by Elsevier B.V.