Roughness of 3D printed surface under influence of chemical post processing

被引：0

作者：

Zolkaply, A. R. ^{[1
]}

Alkahari, M. R. ^{[1
,2
]}

Ramli, F. R. ^{[1
,2
]}

Hamdan, N. S. ^{[3
]}

Sudin, M. N. ^{[1
,2
]}

机构：

[1] Univ Tekn Malaysia Melaka, Fac Mech Engn, Durian Tunggal 76100, Melaka, Malaysia

[2] Univ Tekn Malaysia Melaka, Ctr Adv Res Energy, Durian Tunggal 76100, Melaka, Malaysia

[3] Univ Tekn Malaysia Melaka, Fac Engn Technol, Durian Tunggal 76100, Melaka, Malaysia

来源：

PROCEEDINGS OF MECHANICAL ENGINEERING RESEARCH DAY 2017 (MERD) | 2017年

关键词：

3D printing; additive manufacturing (AM); surface roughness;

D O I：

暂无

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

Fused deposition modeling (FDM) is a popular technology in 3D printing. This is due to its capability to fabricate 3D part faster, effectively, economically and more user-friendly. However, the yield of the printed part is poor in surface finish and it produces staircase effect resulted from layer by layer deposition process. Hence, this paper studies the effect of methyl ethyl ketone (MEK) used as post-processing treatment for acrylonitrile butadiene styrene (ABS) 3D printed part. During the experiment, controlled amount of MEK was applied on 3D printed surface after printing process. This research discovers that the surface finish of 3D printed ABS can be improved significantly with the use of MEK.

引用

页码：153 / 154

页数：2

共 6 条

[1] Analysis on fused deposition modelling performance [J].

Abu Bakar, Nur Saaidah ;

Alkahari, Mohd Rizal ;

Boejang, Hambali .

JOURNAL OF ZHEJIANG UNIVERSITY-SCIENCE A, 2010, 11 (12) :972-977

[2] Quantitative analysis of a chemical treatment to reduce roughness of parts fabricated using fused deposition modeling [J].

Galantucci, L. M. ;

Lavecchia, F. ;

Percoco, G. .

CIRP ANNALS-MANUFACTURING TECHNOLOGY, 2010, 59 (01) :247-250

[3] Experimental study aiming to enhance the surface finish of fused deposition modeled parts [J].

Galantucci, L. M. ;

Lavecchia, F. ;

Percoco, G. .

CIRP ANNALS-MANUFACTURING TECHNOLOGY, 2009, 58 (01) :189-192

[4]

Gao H., 2016, J MINERALS METALS MI, V22, P1

[5] Slicing procedures in layered manufacturing: a review [J].

Pandey, PM ;

Reddy, NV ;

Dhande, SG .

RAPID PROTOTYPING JOURNAL, 2003, 9 (05) :274-288

[6]

Sambasiva R.A., 2012, INT J MECH ENG TECHN, V3, P531

← 1 →