Hyphenated FT-IR-Attenuated Total Reflection and Electrochemical Impedance Spectroscopy Technique to Study the Water Uptake and Potential Stability of Polymeric Solid-Contact Ion-Selective Electrodes

被引:61
作者
Lindfors, Tom [1 ,2 ]
Hoefler, Lajos [3 ,4 ]
Jagerszki, Gyula [5 ]
Gyurcsanyi, Robert E. [3 ,5 ]
机构
[1] Abo Akad Univ, Lab Analyt Chem, Proc Chem Ctr, FI-20500 Turku, Finland
[2] Acad Finland, Helsinki, Finland
[3] Budapest Univ Technol & Econ, Dept Inorgan & Analyt Chem, H-1111 Budapest, Hungary
[4] Univ Michigan, Dept Chem, Ann Arbor, MI 48109 USA
[5] Hungarian Acad Sci, Res Grp Tech Analyt Chem, H-1111 Budapest, Hungary
基金
芬兰科学院;
关键词
LOWER DETECTION LIMIT; SILICONE-RUBBER; POLY(VINYL CHLORIDE); CONDUCTING POLYMERS; MEMBRANES; SENSORS; DIFFUSION; FLUXES; ATR; POLY(3-ALKYLTHIOPHENES);
D O I
10.1021/ac200597b
中图分类号
O65 [分析化学];
学科分类号
070302 ; 081704 ;
摘要
A new hyphenated method utilizing FT-IR-attenuated total reflection (ATR) and electrochemical impedance spectroscopy (EIS) is presented to correlate the water uptake with concomitant potential and impedance changes of polymeric coated-wire electrodes (CWEs) and solid-contact ion-selective electrodes (SCISEs). The Ca(2+)-selective silicone rubber (RTV 3140) based SCISEs with poly(3-octylthiophene) (POT) as the solid-contact (SC) showed good correlation between a very low water content at the Pt-coated ZnSe substrate/SC interface and a superior potential stability. This is due to the hydrophobicity of both RTV 3140 and POT and the approximately 2 orders of magnitude lower water diffusion Coefficients in POT compared to RTV 3140. Practically no potential drift could be observed during 24 h when unconditioned CaSCISEs were contacted with 10(-3) M CaCl(2), in contrast to the Ca(2+)-selective CWEs with considerably higher water uptake and potential drift. The CaSCISEs had a fast Nernstian response with a detection limit of 8 x 10(-9) M Ca(2+) and a good reproducibility and stability of the standard potential, which indicates that the CaSCISEs does not require any conditioning prior to use.
引用
收藏
页码:4902 / 4908
页数:7
相关论文
共 42 条
[1]   Calcium ion-selective electrodes under galvanostatic current control [J].
Bedlechowicz, I ;
Sokalski, T ;
Lewenstam, A ;
Maj-zurawska, M .
SENSORS AND ACTUATORS B-CHEMICAL, 2005, 108 (1-2) :836-839
[2]   Potential stability of all-solid-state ion-selective electrodes using conducting polymers as ion-to-electron transducers [J].
Bobacka, J .
ANALYTICAL CHEMISTRY, 1999, 71 (21) :4932-4937
[3]   Plasticizer-free all-solid-state potassium-selective electrode based on poly(3-octylthiophene) and valinomycin [J].
Bobacka, J ;
Ivaska, A ;
Lewenstam, A .
ANALYTICA CHIMICA ACTA, 1999, 385 (1-3) :195-202
[4]   ALL-SOLID-STATE SODIUM-SELECTIVE ELECTRODE BASED ON A CALIXARENE IONOPHORE IN A POLY(VINYL CHLORIDE) MEMBRANE WITH A POLYPYRROLE SOLID CONTACT [J].
CADOGAN, A ;
GAO, ZQ ;
LEWENSTAM, A ;
IVASKA, A ;
DIAMOND, D .
ANALYTICAL CHEMISTRY, 1992, 64 (21) :2496-2501
[5]   COATED WIRE ION SELECTIVE ELECTRODES [J].
CATTRALL, RW ;
FREISER, H .
ANALYTICAL CHEMISTRY, 1971, 43 (13) :1905-&
[6]   Influence of key parameters on the lower detection limit and response function of solvent polymeric membrane ion-selective electrodes [J].
Ceresa, A ;
Sokalski, T ;
Pretsch, E .
JOURNAL OF ELECTROANALYTICAL CHEMISTRY, 2001, 501 (1-2) :70-76
[7]   EVIDENCE FOR A WATER-RICH SURFACE REGION IN POLY(VINYL CHLORIDE)-BASED ION-SELECTIVE ELECTRODE MEMBRANES [J].
CHAN, ADC ;
LI, XZ ;
HARRISON, DJ .
ANALYTICAL CHEMISTRY, 1992, 64 (21) :2512-2517
[8]   Evidence of a water layer in solid-contact polymeric ion sensors [J].
De Marco, Roland ;
Veder, Jean-Pierre ;
Clarke, Graeme ;
Nelson, Andrew ;
Prince, Kathryn ;
Pretsch, Erno ;
Bakker, Eric .
PHYSICAL CHEMISTRY CHEMICAL PHYSICS, 2008, 10 (01) :73-76
[9]  
Fibbioli M, 2000, ELECTROANAL, V12, P1286, DOI 10.1002/1521-4109(200011)12:16<1286::AID-ELAN1286>3.0.CO
[10]  
2-Q