Preparation, Characterization of Cd(II) Ion-Imprinted Microsphere and Its Selectivity for Template Ion

被引:5
作者
Murat, Aray [1 ]
Wang, Lingling [1 ]
Abliz, Shawket [1 ]
Yimit, Abliz [1 ]
机构
[1] Xinjiang Univ, Sch Chem Engn & Technol, Key Lab Oil & Gas Fine Chem, Minist Educ & Xinjiang Uyghur Autonomous Reg, Urumqi 830017, Peoples R China
基金
中国国家自然科学基金;
关键词
cadmium ion; polymeric microsphere; precipitation polymerization; FAAS; selectivity; AQUEOUS-SOLUTIONS; CADMIUM IONS; POLYMERS; ADSORPTION; REMOVAL; SEPARATION; PRECONCENTRATION; RECOGNITION; EXTRACTION; BEHAVIOR;
D O I
10.3390/coatings12081038
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Cadmium is one of the many toxic elements for humans even at low concentrations, and it could exist in the environment for a long time. The ion imprinting technique has gained much attention due to its selective recognition performance. In this study, a cadmium ion imprinted maleic acid-co-acrylonitrile polymeric microsphere (Cd-I-MA-co-AN) was synthesized via precipitation polymerization using Cd(II) as a template ion, acrylonitrile and maleic acid as functional monomers, divinylbenzene as a cross-linker, and potassium persulfate as an initiator. UV-vis, SEM and FTIR were used for characterization, and the adsorption conditions were observed and optimized. The adsorption capacity and selectivity of Cd-I-MA-co-AN for Cd(II) were analyzed by flame atomic absorption spectrometry (FAAS). The results documented that the optimal pH, flow rate and eluent were 6, 2 mL min(-1) and 1 mol L-1 nitric acid, respectively. Compared with the non-ion imprinted maleic acid-co-acrylonitrile polymeric microsphere (NI-MA-co-AN), Cd-I-MA-co-AN had a higher adsorption capacity. The saturated adsorption capacities of Cd-I-MA-co-AN and NI-MA-co-AN were 20.46 mg g(-1) and 7.64 mg g(-1), respectively. The adsorption behavior of Cd-I-MA-co-AN fitted with the Freundlich isotherm model. The relative selectivity coefficients of Cd-I-MA-co-AN for Cd(II) in the presence of Cu(II), Mn(II), Ni(II) and Pb(II) were 3.79, 3.39, 3.90 and 3.31, respectively. The Cd-I-MA-co-AN showed good selectivity for Cd(II). In addition, a reusability study showed that Cd-I-MA-co-AN can be recycled ten times and has high recovery in natural water samples.
引用
收藏
页数:14
相关论文
共 48 条
[1]   Removal of cadmium ions from industrial waste water plants around Cairo [J].
Abdel-Halim, SH ;
Shehata, AMA ;
El-Shahat, MF .
BULLETIN OF ENVIRONMENTAL CONTAMINATION AND TOXICOLOGY, 2005, 74 (01) :78-85
[2]   Synthesis, characterization and application of a novel ion hybrid imprinted polymer to adsorb Cd(II) in different samples [J].
Adauto, Anais ;
Khan, Sabir ;
da Silva, Matheus Augusto ;
Gomes Neto, Jose Anchieta ;
Picasso, Gino ;
Taboada Sotomayor, Maria del Pilar .
ENVIRONMENTAL RESEARCH, 2020, 187
[3]   A Review on Heavy Metal Ions and Dye Adsorption from Water by Agricultural Solid Waste Adsorbents [J].
Afroze, Sharmeen ;
Sen, Tushar Kanti .
WATER AIR AND SOIL POLLUTION, 2018, 229 (07)
[4]   Preparation of a new nanoparticle Cd(II)-imprinted polymer and its application for selective separation of cadmium(II) ions from aqueous solutions and determination via inductively coupled plasma optical emission spectrometry [J].
Ashouri, Nasim ;
Mohammadi, Ali ;
Hajiaghaee, Reza ;
Shekarchi, Maryam ;
Khoshayand, Mohammad Reza .
DESALINATION AND WATER TREATMENT, 2016, 57 (30) :14280-14289
[5]   Recognition principle of Cu2+ imprinted polymers Assessing interactions by combined spectroscopic and mass-sensitive measurements [J].
Bajwa, Sadia Zafar ;
Lieberzeit, Peter A. .
SENSORS AND ACTUATORS B-CHEMICAL, 2015, 207 :976-980
[6]   Molecularly Imprinted Polymers [J].
BelBruno, Joseph J. .
CHEMICAL REVIEWS, 2019, 119 (01) :94-119
[7]   A novel paraoxon imprinted electrochemical sensor based on MoS2NPs@MWCNTs and its application to tap water samples [J].
Bolukbasi, Omer Saltuk ;
Yola, Bahar Bankoglu ;
Boyacioglu, Havva ;
Yola, Mehmet Lutfi .
FOOD AND CHEMICAL TOXICOLOGY, 2022, 163
[8]   Recent advances on ion-imprinted polymers [J].
Branger, Catherine ;
Meouche, Walid ;
Margaillan, Andre .
REACTIVE & FUNCTIONAL POLYMERS, 2013, 73 (06) :859-875
[9]   Effect of ethylene diamine tetra-acetic acid and functional monomers on the structure and adsorption properties of copper (II) ion-imprinted polymers [J].
Chaipuang, Angkana ;
Phungpanya, Chalida ;
Thongpoon, Chalermporn ;
Watla-iad, Kanchana ;
Inkaew, Prachak ;
Machan, Theeraphan ;
Suwantong, Orawan .
POLYMERS FOR ADVANCED TECHNOLOGIES, 2021, 32 (08) :3000-3007
[10]   Highly selective removal of kitasamycin from the environment by molecularly imprinted polymers: Adsorption performance and mechanism [J].
Chen, Jingfan ;
Wang, Lifang ;
Liu, Yongli ;
Chen, Letian ;
Li, Xian ;
Wang, Xuefeng ;
Zhu, Guifen .
COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2021, 625