Effects of Sb on the Charge Transport and Power Factor of Bi2-xSbxTe3 Thermoelectric Compounds Prepared by Hot Pressing

被引:10
|
作者
Lim, Young Soo [1 ]
Lee, Soonil [2 ]
机构
[1] Pukyong Natl Univ, Dept Mat Syetem Engn, Busan 48547, South Korea
[2] Korea Inst Ceram Engn & Technol, Energy & Environm Div, Jinju 52851, South Korea
来源
KOREAN JOURNAL OF METALS AND MATERIALS | 2017年 / 55卷 / 09期
关键词
thermoelectric; bismuth telluride; hot pressing; charge transport; power factor; BISMUTH TELLURIDE; ANTISITE DEFECTS; CU INCORPORATION; GENERATION; ALLOYS; CRYSTALS; FIGURE; MERIT;
D O I
10.3365/KJMM.2017.55.9.651
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
We report the effects of Sb content on the charge transport and power factor of Bi2-xSbxTe3(1.56 <= x <= 1.74) compounds prepared by hot pressing. From the temperature-dependence of the electrical conductivity, it was found that the charge transport in the compounds was predominantly governed by acoustic phonon scattering, and additionally affected by ionized impurity scattering. Hole concentration increased with increasing Sb content due to the generation of antisite defects, and its process-dependence is discussed in comparison with our previous work. The room-temperature mobility of the compound gradually decreased with increasing Sb content due to the intensification of ionized impurity scattering by the antisite defects, however, the effect of grain boundary scattering on the mobility could not be observed. The Seebeck coefficient decreased with the increase in Sb content, and this effect was interpreted in terms of the carrier concentration and the density-of-state (DOS) effective mass. The DOS effective mass was estimated by Pisaernko relation, and it increased from 0.75 (x = 1.56) to 0.97 (x = 1.74) with increasing Sb content due to the non-parabolicity in the valence band of Bi2-xSbxTe3. Based on these results, the effects of Sb content on the power factor were discussed, and the highest power factor of 37.2 x 10(4) Wm(-1)K(-2) was obtained in the Bi0.3Sb1.7Te8 compound at room temperature.
引用
收藏
页码:651 / 656
页数:6
相关论文
共 50 条
  • [41] Thermoelectric Properties of Cu-doped Bi0.4Sb1.6Te3 Prepared by Hot Extrusion
    Woo-Jin Jung
    Il-Ho Kim
    Journal of Electronic Materials, 2018, 47 : 3136 - 3142
  • [42] Mechanical and thermal processing effects on crystal defects and thermoelectric transport properties of Bi2(Se,Te)3 compounds
    Lu, Meng-Pei
    Liao, Chien-Neng
    JOURNAL OF ALLOYS AND COMPOUNDS, 2013, 571 : 178 - 182
  • [43] Effect of oxygen content on thermoelectric properties of n-type (Bi,Sb)2(Te,Se)3 alloys prepared by rapid solidification and hot-pressing techniques
    Horio, Yuma
    Inoue, Akihisa
    MATERIALS TRANSACTIONS, 2006, 47 (05) : 1412 - 1416
  • [44] Thermoelectric properties of n-type (Bi2Se3)x(Bi2Te3)1-x prepared by bulk mechanical alloying and hot pressing
    Yang, JY
    Aizawa, T
    Yamamoto, A
    Ohta, T
    JOURNAL OF ALLOYS AND COMPOUNDS, 2000, 312 (1-2) : 326 - 330
  • [45] Effects of hot pressing on electric performances of Bi0.5Sb1.5Te3
    Xiao Bo
    Chen Hui
    Wu Borong
    Zhu Lei
    Liu Mingyi
    Jian Xuyu
    Li Lin
    RARE METALS, 2006, 25 : 320 - 323
  • [46] Effects of hot pressing on electric performances of Bi0.5Sb1.5Te3
    XIAO Bo1)
    RareMetals, 2006, (S1) : 320 - 323
  • [47] Thermoelectric and mechanical properties of Bi0.4Sb1.6Te3 prepared by using encapsulated melting and hot extrusion
    Woo-Jin Jung
    Il-Ho Kim
    Journal of the Korean Physical Society, 2017, 70 : 511 - 516
  • [48] Thermoelectric Behaviors of Bi0.3Sb1.7Te3.0 with Excess or Deficiency of Tellurium Prepared by Mechanical Alloying Followed by Hot Pressing
    Hirota, Kenji
    Kitamura, Masato
    Takagi, Katsuhiro
    Hasezaki, Kazuhiro
    MATERIALS TRANSACTIONS, 2018, 59 (08) : 1233 - 1238
  • [49] Thermoelectric Properties of the Bi2Te3 Compound Prepared by an Aqueous Chemical Method Followed by Hot Pressing
    T. Zhang
    J. M. Chen
    J. Jiang
    Y. L. Li
    W. Li
    G. J. Xu
    Journal of Electronic Materials, 2011, 40 : 1107 - 1110
  • [50] Thermoelectric properties of p-type (Bi,Sb)2Te3 alloys fabricated by the hot pressing method
    Kim, HJ
    Kim, HC
    Hyun, DB
    Oh, TS
    METALS AND MATERIALS INTERNATIONAL, 1998, 4 (01) : 75 - 81