Design for manufacturability of SISE parallel plate forced convection heat sinks

被引：39

作者：

Iyengar, M ^{[1
]}

Bar-Cohen, A ^{[1
]}

机构：

[1] Univ Minnesota, Dept Mech Engn, TherMNS Lab, Minneapolis, MN 55455 USA

来源：

IEEE TRANSACTIONS ON COMPONENTS AND PACKAGING TECHNOLOGIES | 2001年 / 24卷 / 02期

关键词：

bonding; design for manufacturability; folding; forging; least-material; machining; modified die-casting; optimization; skiving;

D O I：

10.1109/6144.926377

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

The study reported herein extends a previously reported "design for mannfacturability" methodology, to forced convection cooled rectangular plate heat sinks, Using a well validated analytical model, the thermofluid performance of the side-inletside-exit (SISE) heat sink has been characterized, parametric optimization carried out, and the maximum heat transfer capabilities fora range of operating points has been determined. A least-material optimization has been performed to achieve optimal material use, The analysis indicates the least-material design to provide significant mass, savings for a moderate penalty in thermal performance. Empirical criteria for manufacturability obtained from several heat sink manufacturers lead to qualitative guidelines.

引用

页码：150 / 158

页数：9

共 13 条

[1] Bar-Cohen A., 1986, HEAT TRANSFER ENG, V6, P68
[2] BARCOHEN A, 1998, P HEAT EXCH SUST DEV, P43
[3] BENACHOUR MF, 1999, P ASME ADV EL PACK, V26, P737
[4] GARNER SD, 1997, P ASME ADV EL PA EEP, V19, P1897
[5] HOLAHAN MF, 1996, P 31 NAT HEAT TRANSF, V7, P63
[6] IWASAKI H, 1994, P INT C THERM PHEN, P144
[7] Least-material optimization of vertical pin-fin, plate-fin, and triangular-fin heat sinks in natural convective heat transfer
Iyengar, M
Bar-Cohen, A
[J]. ITHERM '98: SIXTH INTERSOCIETY CONFERENCE ON THERMAL AND THERMOMECHANICAL PHENOMENA IN ELECTRONIC SYSTEMS, 1998, : 295 - 302
[8] Kakac S., 1987, HDB SINGLE PHASE CON
[9] Kern D., 1972, EXTENDED SURFACE HEA
[10] *NJ ZINC CO, 1953, DIE CAST ENG

← 1 2 →