Performance analysis of proton exchange membrane fuel cell in automotive applications

被引：30

作者：

Pahon, E. ^{[1
]}

Bouquain, D. ^{[2
]}

Hissel, D. ^{[2
]}

Rouet, A. ^{[3
]}

Vacquier, C. ^{[3
]}

机构：

[1] Univ Bourgogne Franche Comte, UTBM, CNRS, FEMTO ST Inst,FCLAB, Belfort, France

[2] Univ Bourgogne Franche Comte, FCLAB, CNRS, FEMTO ST Inst, Belfort, France

[3] SYMBIO, Venissieux, France

来源：

JOURNAL OF POWER SOURCES | 2021年 / 510卷

关键词：

Proton exchange membrane fuel cell; Start; stop cycling; Durability; Performance analysis; Degradation mechanisms; Oxygen reduction reaction; SHUT-DOWN STRATEGY; CARBON CORROSION; VEHICLES; CYCLES;

D O I：

10.1016/j.jpowsour.2021.230385

中图分类号：

O64 [物理化学（理论化学）、化学物理学];

学科分类号：

070304 ; 081704 ;

摘要：

This paper deals with the performance analysis of a proton exchange membrane fuel cell in automotive applications and especially for start/stop phases. Start-Stop cycles are one of the main sources of degradation for fuel cell systems, embedded in the automotive applications, among other dynamic conditions as idling, load cycling or high power. In this study, polarization curves and electrochemical impedance spectra are used to analyze the degradation mechanisms inside fuel cell stack during start/stop cycling. Obviously, the carbon support of the catalyst layer is the main constituent that suffers performance degradation during the 2,600 successive cycles performed. The impedance measurement of a 5 kW PEM fuel cell stack revealed that the ohmic resistance does not vary whereas the charger transfer and mass transfer resistances increase drastically depending on the number of cycle repetitions. The oxygen reduction reaction impact due to the fuel/air interface is also visible even if the reactants are consumed with a dummy load for the shutdowns.

引用

页数：7

共 33 条

[1] Statistically supported real driving emission calibration: Using cycle generation to provide vehicle-specific and statistically representative test scenarios for Euro 7 [J].

Classen, Johannes ;

Pischinger, Stefan ;

Krysmon, Sascha ;

Sterlepper, Stefan ;

Dorscheidt, Frank ;

Doucet, Matthieu ;

Reuber, Christoph ;

Goergen, Michael ;

Scharf, Johannes ;

Nijs, Martin ;

Thewes, Silja Christine .

INTERNATIONAL JOURNAL OF ENGINE RESEARCH, 2020, 21 (10) :1783-1799

[2] Use of mechanistic carbon corrosion model to predict performance loss in Polymer Electrolyte Membrane fuel cells [J].

Dhanushkodi, S. R. ;

Kundu, S. ;

Fowler, M. W. ;

Pritzker, M. D. .

JOURNAL OF POWER SOURCES, 2014, 267 :171-181

[3]

DOE Hydrogen, 2017, FUEL CELL TECHN TEAM

[4]

E. Commission, 2020, CO2 EM PERF STAND CA

[5]

European Environment Agency, 2020, GREENHOUSE GAS EMISS

[6] Energy management of heavy-duty fuel cell vehicles in real-world driving scenarios: Robust design of strategies to maximize the hydrogen economy and system lifetime [J].

Ferrara, Alessandro ;

Jakubek, Stefan ;

Hametner, Christoph .

ENERGY CONVERSION AND MANAGEMENT, 2021, 232

[7] Challenges in the designing, planning and deployment of hydrogen refueling infrastructure for fuel cell electric vehicles [J].

Greene, David L. ;

Ogden, Joan M. ;

Lin, Zhenhong .

ETRANSPORTATION, 2020, 6

[8] Performance and regulated gaseous emissions of a Euro 6 diesel vehicle with Lean NOx Trap at different ambient conditions: Sensitivity to the type of fuel [J].

Hernandez, Juan J. ;

Rodriguez-Fernandez, J. ;

Calle-Asensio, A. .

ENERGY CONVERSION AND MANAGEMENT, 2020, 219 (219)

[9] Mechanisms of reverse current and mitigation strategies in proton exchange membrane fuel cells during startups [J].

Jia, Fei ;

Liu, Fengfeng ;

Guo, Liejin ;

Liu, Hongtan .

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2016, 41 (15) :6469-6475

[10] An insight into potential early adopters of hydrogen fuel-cell vehicles in Japan [J].

Khan, Urwah ;

Yamamoto, Toshiyuki ;

Sato, Hitomi .

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2021, 46 (18) :10589-10607

← 1 2 3 4 →