An Intermediate Frequency Amplifier for High-Temperature Applications

被引:5
|
作者
Hussain, Muhammad Waqar [1 ]
Elahipanah, Hossein [1 ]
Schroder, Stephan [1 ]
Rodriguez, Saul [1 ]
Malm, Bengt Gunnar [1 ]
Ostling, Mikael [1 ]
Rusu, Ana [1 ]
机构
[1] KTH Royal Inst Technol, S-11428 Stockholm, Sweden
关键词
4H-silicon carbide (4H-SiC) bipolar junction transistors (BJTs); high temperature; intermediate frequency (IF) amplifiers; matching networks; HIGH-EFFICIENCY; CURRENT GAIN; CONTACTS; NOISE; GATE;
D O I
10.1109/TED.2018.2804392
中图分类号
TM [电工技术]; TN [电子技术、通信技术];
学科分类号
0808 ; 0809 ;
摘要
This paper presents a two-stage small signal intermediate frequency amplifier for high-temperature communication systems. The proposed amplifier is implemented using in-house silicon carbide bipolar technology. Measurements show that the proposed amplifier can operate from room temperature up to 251 degrees C. At a center frequency of 54.6MHz, the amplifier has a gain of 22 dB at room temperature, which decreases gradually to 16 dB at 251 degrees C. Throughout the measured temperature range, it achieves an input and output return loss of less than -7 and -11 dB, respectively. The amplifier has a 1-dB output compression point of about 1.4 dBm, which remains fairly constant with temperature. Each amplifier stage is biased with a collector current of 10 mA and a base-collector voltage of 3 V. Under the aforementioned biasing, the maximum power dissipation of the amplifier is 221 mW.
引用
收藏
页码:1411 / 1418
页数:8
相关论文
共 50 条
  • [31] The possibility of Cr-base alloys for high-temperature applications
    Gu, YF
    Ro, Y
    Harada, H
    PRICM 5: THE FIFTH PACIFIC RIM INTERNATIONAL CONFERENCE ON ADVANCED MATERIALS AND PROCESSING, PTS 1-5, 2005, 475-479 : 627 - 630
  • [32] Wireless micromachined ceramic pressure sensor for high-temperature applications
    Fonseca, MA
    English, JM
    von Arx, M
    Allen, MG
    JOURNAL OF MICROELECTROMECHANICAL SYSTEMS, 2002, 11 (04) : 337 - 343
  • [33] SiC CMOS Gate Driver for High-Temperature Aerospace Applications
    Torres, Felipe
    Martinez, Andres
    Marin, Jorge
    Rojas, Christian A.
    Gak, Joel
    Rommel, Mathias
    Wilson-Veas, Alan H.
    May, Alexander
    Schraml, Michael
    Calarco, Nicolas
    Miguez, Matias
    2024 ARGENTINE CONFERENCE ON ELECTRONICS, CAE, 2024, : 99 - 102
  • [34] High-Temperature Gas Sensors for Harsh Environment Applications: A Review
    Ghosh, Abhishek
    Zhang, Chen
    Shi, Sheldon Q.
    Zhang, Haifeng
    CLEAN-SOIL AIR WATER, 2019, 47 (08)
  • [35] Investigation of Two High-Temperature Bipolar Phenomena and Characteristics of 1.2-kV SiC Power Diodes for High-Temperature Applications
    Zhu, Mengyu
    Pei, Yunqing
    Yang, Fengtao
    Xue, Zhe
    Ma, Dingkun
    Wang, Laili
    IEEE JOURNAL OF EMERGING AND SELECTED TOPICS IN POWER ELECTRONICS, 2024, 12 (01) : 651 - 662
  • [36] High-Temperature General Purpose Operational Amplifier in IBM 0.13 μm CMOS Process
    Wang, Yucai
    Chodavarapu, Vamsy P.
    2014 IEEE INTERNATIONAL CONFERENCE ON ELECTRON DEVICES AND SOLID-STATE CIRCUITS (EDSSC), 2014,
  • [37] Ionic liquid electrolyte selection for high voltage supercapacitors in high-temperature applications
    Bahaa, Ahmed
    Alhammadi, Ayoob
    Lethesh, Kallidanthiyil Chellappan
    Susantyoko, Rahmat Agung
    Bamgbopa, Musbaudeen O.
    FRONTIERS IN CHEMISTRY, 2024, 12
  • [38] Reciprocating Shaft Seals for High-Temperature and High-Pressure Applications: A Review
    McKee, Michael
    Gordaninejad, Faramarz
    JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME, 2018, 140 (03):
  • [39] Progress in heat transfer research for high-temperature solar thermal applications
    Lipinski, Wojciech
    Abbasi-Shavazi, Ehsan
    Chen, Jingjing
    Coventry, Joe
    Hangi, Morteza
    Iyer, Siddharth
    Kumar, Apurv
    Li, Lifeng
    Li, Sha
    Pye, John
    Torres, Juan F.
    Wang, Bo
    Wang, Ye
    Wheeler, Vincent M.
    APPLIED THERMAL ENGINEERING, 2021, 184
  • [40] DESIGN EVALUATION OF A SMALL HIGH-TEMPERATURE REACTOR FOR PROCESS HEAT APPLICATIONS
    BARNERT, H
    SINGH, J
    NUCLEAR ENGINEERING AND DESIGN, 1988, 109 (1-2) : 245 - 251