Intraosseous generation of heat during guided surgical drilling: an ex vivo study of the effect of the temperature of the irrigating fluid

We measured the rise in the intraosseous temperature caused by freehand drilling or drilling through a surgical guide, by comparing different temperatures of irrigation fluid (10 degrees C, 15 degrees C, and 20 degrees C), for every step of the drilling sequence (diameters 2.0, 2.5, 3.0, and 3.5 mm) and using a constant drilling speed of 1200 rpm. The axial load was controlled at 2.0 kg. Bovine ribs were used as test models. In the guided group we used 3-dimensional printed surgical guides and temperature was measured with a thermocouple. The significance of differences was assessed with the Kruskal-Wallis analysis of variance. Guided drilling with 10 degrees C irrigation yielded a significantly lower increment in temperature than the 20 degrees C-guided group. When compared with the 20 degrees C freehand group, the reduction in temperature in the 10 degrees C guided group was significantly more pronounced at all diameters except 3.5 mm Finally, when the 10 degrees C-guided group was compared with the 15 degrees C groups, the temperature rise was significantly less at 2.5 and 3.0 mm than with the guided technique, and at 3.0 mm compared with the freehand technique. We suggest that the use of 10 degrees C pre-cooled irrigation fluid is superior to warmer fluid for keeping temperature down, and this reduces the difference between guided and freehand drilling. (C) 2016 The British Association of Oral and Maxillofacial Surgeons. Published by Elsevier Ltd. All rights reserved.