共 22 条
- [21] [No title captured]
- [22] [No title captured]
An experimental investigation on mechanisms for manufacturing induced shape distortions in homogeneous and balanced laminates
被引：88
作者：
Svanberg, JM
Holmberg, JA
机构：
[1] SICCOMP AB, Swedish Inst Composites, SE-94126 Pitea, Sweden
[2] Lulea Univ Technol, Div Polymer Engn, SE-97187 Lulea, Sweden
关键词：
spring-in;
residual/internal stress;
cure;
laminates;
D O I：
10.1016/S1359-835X(00)00173-1
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
Manufacturing induced shape distortions is a common problem for composite manufacturers. For single curved geometries the phenomenon is known as spring-in. Today a lot of effort is spent to develop modelling tools for prediction of spring-in and shape distortions in general. However, good experimental data is rare in the literature and there are no established constitutive models capable of account for the effect from different cure schedules. In this paper, experimental data for spring-in of glass-fibre epoxy composites are presented. The experiments were performed with angle brackets manufactured by RTM, in a steel mould with accurate temperature control. Different in-mould temperature have been used to point out and separate different mechanisms responsible for spring-in. (C) 2001 Elsevier Science Ltd. All rights reserved.
引用
收藏
页码：827 / 838
页数：12
相关论文