Characterization of Strength of Intact Brittle Rock Considering Confinement-Dependent Failure Processes

被引:90
作者
Kaiser, Peter K. [1 ]
Kim, Bo-Hyun [2 ,3 ]
机构
[1] CEMI, Sudbury, ON, Canada
[2] Laurentian Univ, Geomech Res Ctr MIRARCO, Sudbury, ON P3E 2C6, Canada
[3] Itasca Consulting Grp Inc, Minneapolis, MN 55401 USA
基金
加拿大自然科学与工程研究理事会;
关键词
Brittle failure; Intact rock strength; Failure criteria; Confinement; FRACTURE; PROPAGATION;
D O I
10.1007/s00603-014-0545-5
中图分类号
P5 [地质学];
学科分类号
0709 ; 081803 ;
摘要
As technologies for deep underground development such as tunneling underneath mountains or mass mining at great depths (> 1,000 m) are implemented, more difficult ground conditions in highly stressed environments are encountered. Moreover, the anticipated stress level at these depths easily exceeds the loading capacity of laboratory testing, so it is difficult to properly characterize what the rock behavior would be under high confinement stress conditions. If rock is expected to fail in a brittle manner, behavior changes associated with the relatively low tensile strength, such as transition from splitting to the shear failure, have to be considered and reflected in the adopted failure criteria. Rock failure in tension takes place at low confinement around excavations due to tensile or extensional failure in heterogeneous rocks. The prospect of tensile-dominant brittle failure diminishes as the confinement increases away from the excavation boundary. Therefore, it must be expected that the transition in the failure mechanism, from tensile to shear, occurs as the confinement level increases and conditions for extensional failure are prevented or strongly diminished. However, conventional failure criteria implicitly consider only the shear failure mechanism (i.e., failure envelopes touching Mohr stress circles), and thus, do not explicitly capture the transition of failure modes from tensile to shear associated with confinement change. This paper examines the methodologies for intact rock strength determination as the basic input data for engineering design of deep excavations. It is demonstrated that published laboratory test data can be reinterpreted and better characterized using an s-shaped failure criterion highlighting the transition of failure modes in brittle failing rock. As a consequence of the bi-modal nature of the failure envelope, intact rock strength data are often misinterpreted. If the intact rock strength is estimated by standard procedures from unconfined compression tests (UCS) alone, the confined strength may be underestimated by as much as 50 % (on average). If triaxial data with a limited confinement range (e.g., sigma(3) a parts per thousand(a) 0.5 UCS due to cell pressure limitations) are used, the confined strength may be overestimated. Therefore, the application of standard data fitting procedures, without consideration of confinement-dependent failure mechanisms, may lead to erroneous intact rock strength parameters when applied to brittle rocks, and consequently, by extrapolation, to correspondingly erroneous rock mass strength parameters. It follows that the strength characteristics of massive rock differ significantly in the direct vicinity of excavation from that which is remote with higher confinement. Therefore, it is recommended to adopt a differentiated approach to obtain intact rock strength parameters for engineering problems at lower confinement (near excavation; e.g., excavation stability assessment or support design), and at elevated confinement (typically, when the confinement exceeds about 10 % of the UCS) as might be encountered in wide pillar cores.
引用
收藏
页码:107 / 119
页数:13
相关论文
共 42 条
  • [1] Crack Initiation and Crack Propagation in Heterogeneous Sulfate-Rich Clay Rocks
    Amann, Florian
    Undul, Omer
    Kaiser, Peter K.
    [J]. ROCK MECHANICS AND ROCK ENGINEERING, 2014, 47 (05) : 1849 - 1865
  • [2] Experimental Study of Brittle Behavior of Clay Shale in Rapid Triaxial Compression
    Amann, Florian
    Kaiser, Peter
    Button, Edward Alan
    [J]. ROCK MECHANICS AND ROCK ENGINEERING, 2012, 45 (01) : 21 - 33
  • [3] Experimental Study of the Brittle Behavior of Clay shale in Rapid Unconfined Compression
    Amann, Florian
    Button, Edward Alan
    Evans, Keith Frederick
    Gischig, Valentin Samuel
    Bluemel, Manfred
    [J]. ROCK MECHANICS AND ROCK ENGINEERING, 2011, 44 (04) : 415 - 430
  • [4] Bewick RP, 2011, P 45 US ROCK MECH S
  • [5] Diederichs M.S., 1999, Instability of Hard Rockmasses, the Role of Tensile Damage and Relaxation
  • [6] Damage initiation and propagation in hard rock during tunnelling and the influence of near-face stress rotation
    Diederichs, MS
    Kaiser, PK
    Eberhardt, E
    [J]. INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES, 2004, 41 (05) : 785 - 812
  • [7] Manuel Rocha Medal recipient - Rock fracture and collapse under low confinement conditions
    Diederichs, MS
    [J]. ROCK MECHANICS AND ROCK ENGINEERING, 2003, 36 (05) : 339 - 381
  • [8] CRITICAL STATE CONCEPT APPLIED TO ROCK
    GEROGIANNOPOULOS, NG
    BROWN, ET
    [J]. INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES, 1978, 15 (01): : 1 - 10
  • [9] Griffith A.A., 1924, Proceedings from the 1st International Congress on Applied Mechanics, Delft, Netherlands, P54, DOI DOI 10.12691/AJME-5-3-4
  • [10] Griffith Alan Arnold, 1921, Phil. Trans. Roy. Soc., V221, P163, DOI DOI 10.1098/RSTA.1921.0006