共 51 条
Study of structural properties and defects of Ni-doped SnO2 nanorods as ethanol gas sensors
被引:27
作者:
Inderan, Vicinisvarri
[1
,2
]
Arafat, M. M.
[3
]
Kumar, Sudesh
[4
]
Haseeb, A. S. M. A.
[3
]
Jiang, Zhong-Tao
[5
]
Altarawneh, Mohammednoor
[5
]
Lee, Hooi Ling
[1
]
机构:
[1] Univ Sains Malaysia, Nanomat Res Grp, Sch Chem Sci, George Town 11800, Malaysia
[2] Univ Teknol Mara, Dept Appl Sci, Kampus Permatang Pauh, George Town, Malaysia
[3] Univ Malaya, Dept Mech Engn, Fac Engn, Kuala Lumpur 50603, Malaysia
[4] Univ Sains Malaysia, Sch Biol Sci, George Town 11800, Malaysia
[5] Murdoch Univ, Sch Engn & Informat Technol, Surface Anal & Mat Engn Res Grp, Murdoch, WA 6150, Australia
关键词:
hydrothermal;
nickel doped;
tin oxide;
nanorods;
ethanol;
gas sensor;
SENSING PROPERTIES;
HYDROTHERMAL SYNTHESIS;
NANOPARTICLES;
TEMPERATURE;
CO;
NANOSTRUCTURES;
PRECIPITATION;
ALKALINE;
POWDERS;
SURFACE;
D O I:
10.1088/1361-6528/aa731c
中图分类号:
TB3 [工程材料学];
学科分类号:
0805 ;
080502 ;
摘要:
An ethanol gas sensor with enhanced sensor response was fabricated using Ni-doped SnO2 nanorods, synthesized via a simple hydrothermal method. It was found that the response (R = R-0/R-g) of a 5.0 mol% Ni-doped SnO2 (5.0Ni:SnO2) nanorod sensor was 1.4 x 10(4) for 1000 ppm C2H5OH gas, which is about 13 times higher than that of pure SnO2 nanorods, (1.1 x 10(3)) at the operating temperature of 450 degrees C. Moreover, for 50 ppm C2H5OH gas, the 5.0Ni:SnO2 nanorod sensor still recorded a significant response reading, namely 2.0 x 10(3) with a response time of 30 s and recovery time of 10 min. To investigate the effect of Ni dopant (0.5-5.0 mol%) on SnO2 nanorods, structural characterizations were demonstrated using field emission scanning electron microscopy, high-resolution transmission electron microscopy, Fourier transform infrared spectroscopy, x-ray diffraction (XRD) analysis, x-ray photoelectron spectroscopy and an ultraviolet-visible spectrometer. XRD results confirmed that all the samples consisted of tetragonal-shaped rutile SnO2 nanorods. It was found that the average diameter and length of the nanorods formed in 5.0Ni:SnO2 were four times smaller (similar to 6 and similar to 35 nm, respectively) than those of the nanorods formed in pure SnO2 (similar to 25 and 150 nm). Interestingly, both samples had the same aspect ratio, similar to 6. It is proposed that the high response of the 5.0Ni:SnO2 nanorod sensor can be attributed to the particle size, which causes an increase in the thickness of the charge depletion layer, and the presence of oxygen vacancies within the matrix of SnO2 nanorods.
引用
收藏
页数:11
相关论文