Study of deuterium permeation, retention, and desorption in SiC coatings submitted to relevant conditions for breeder blanket applications: thermal cycling effect under electron irradiation and oxygen exposure

In this paper we report on the performance as deuterium permeation barriers of sputtered amorphous, dense and not fully stoichiometric SiC coatings under relevant conditions for breeder blanket applications in fusion reactors. To do that, we investigate the following effects on permeation values: (i) thermal cycling at 450 degrees C, (ii) combined thermal cycling and e(-) irradiation (1.8 MeV up to a total dose of 1 MGy), as well as (iii) oxygen exposure at a temperature of 450 degrees C during e(-) irradiation. Data show that the permeation reduction factor (PRF) for the as-deposited SiC coated is similar to 10(-4) , even at the predicted operation temperature for the breeder and it is slightly reduced either by thermal cycling without and during e(-) irradiation. However, the exposure to oxygen at 450 degrees C during e(-) irradiation leads to degradation of the coating and of its PRF of about three orders of magnitude. The origin of the coating degradation is discussed. We also study the D retention and desorption in SiC coatings that were implanted with D at energy of 7.5 keV prior to (as-deposited) and after being submitted to the treatments previously described. Secondary ion mass spectroscopy data show that thermal cycling, without and during e(-) irradiation, strongly increases the D retention in the coatings and leads to the appearance of D-2 desorption peak at temperatures between similar to 400-750 degrees C, whereas e-irradiation during thermal cycling does not significantly change the D retention but shifts to higher temperatures thisD(2) desorption peak (C) 2021 Elsevier B.V. All rights reserved.