Preparation and characterization of micro components fabricated by micro powder injection molding

Given the dimension of the micro component to be replicated, it is crucial to study sintering for dimensional and property control in micro powder injection molding. In the paper, 316 L stainless steel micro components with two different microsize structure dimensions, phi 100 mu m x height 200 mu m and phi 60 mu m x height 191 mu m, are fabricated from in-house feedstock. Shrinkage, microstructure, microindentation hardness and sintering trajectory are investigated for the micro components. The linear shrinkage rate of the micro component reaches the maximum at 1180 degrees C, after which it begins to decline. Porosity (volume fraction of pores) decrease, pore migration and breakaway, grain growth and the formation of a dense layer are observed for the microsize structures. The microindentation hardness of the dense layer in the rim of the microsize structures is lower than the microindentation hardness of the substructure. It is found that if the relative density is below 0.98, densification is promoted when the structure size reduces from the substructure in the millimeter regime to the microsize structures of phi 60 mu m. This is attributed to the oxides on the debound micro components and internal gas pressure produced by hydrogen sintering. (C) 2011 Elsevier Inc. All rights reserved.