Structural and dynamic electromagnetic properties of Ni0.27Cu0.10Zn0.63AlxFe2-xO4

The influence of Al substitution on the structural and electromagnetic properties of Ni0.27Cu0.10Zn0.63Al,Fe2-xO4; (where x = 0.0 to x = 0.16 with step = 0.02) prepared by the combustion technique, has been investigated. X-ray diffraction analysis confirms the presence of single phase cubic spinet structure without any secondary phase. The lattice constant, theoretical density, bulk density and average grain size decreases with increasing Al content. B-H loops have been traced for all the compositions and the various hysteresis parameters like saturation induction, coercivity, remanance, remanance ratio and power loss have been studied as a function of Al content. The saturation induction and the initial permeability increases with sintering temperature up to 1150 degrees C where the maximum bulk density is obtained, while for higher sintering temperature they decrease. The variation of complex initial permeability for Al substituted NiCuZn ferrites can be presented as a form of semicircle so called the Cole-Cole plot and the relaxation phenomena were explained with various shapes of the plots. The analysis of complex impedance spectra by an equivalent circuit model were used to separate the grain and grain boundary resistance of various Ni0.27Cu0.10Zn0.63AlxFe2-xO4. The impedance plot showed the first semicircle at high frequency which corresponds to grain effect and the second semicircle at lower frequency which corresponds to grain boundary (conduction phenomenon). Both grain and grain boundary resistance increases with increasing Al content and the relative increase of grain resistance is larger than the grain boundary resistance. The frequency dependent conductivity results support the double (Jonscher's modified) power law,or (omega) = sigma(o) + A(1)(n1) + A(2)omega(n2), and the results showed evidence of three types of conduction process at room temperature: (i) low frequency conductivity is due to longrange ordering (frequency independent or its tendency, region I), (ii) mid frequency conductivity may be due to the short range hopping (dispersion and frequency independent plateau, region II) and (iii) high frequency conduction is due to the localized relaxation (region Ill) hopping mechanism. (C) 2015 Elsevier By. All rights reserved.