Casting Process at Roll Bite in Strip Cast Using Vertical-Type High-Speed Twin-Roll Caster

The solidification process in strip casting using a vertical-type high-speed twin-roll caster was clarified by inserting a 0.1 mm diameter K-type thermocouple into a strip during casting. The roll speeds of the copper rolls were 10 m/min and 30 m/min, and the roll loads were 5 kN and 20 kN. Al-Si alloys with a Si content of 2%, 6%, and 12% were used to investigate the influence of latent heat and viscosity in the semisolid state. The strip temperature increased after exiting the rolls. This indicated that the inside of the strip had not completely solidified at the roll bite, and secondary cooling was necessary to rapidly solidify the inside of the strip. The distance from the roll bite to the solidification starting position ranged from 30 mm to 63 mm. The cooling rate and degree of supercooling increased as the Si content decreased. The cooling rate ranged from 400 degrees C/s to 4000 degrees C/s. The cooling rate and degree of supercooling decreased as the viscosity of the semisolid increased.