Radiation exposure with use of the inverted-c-arm technique in upper-extremity surgery

Background: Intraoperative fluoroscopy is commonly used in surgical procedures on upper extremities. We compared radiation exposure from two possible positions of the mobile digital fluoroscopy unit (c-arm): (1) the standard technique, with the x-ray tube down (near the floor) and the image intensifier at the top of the c-arm, and (2) the inverted position, in which the image intensifier is used as a table and the x-ray tube is up. Methods: A commercially available c-arm was used to irradiate a phantom hand in one of three configurations.,ln the first, the phantom hand was placed on an armboard equidistant from the x-ray tube and the image intensifier with the beam directed upward. In the second, the c-arm was inverted with the beam directed downward and the image intensifier used as a table. The third configuration was identical to the second except that a magnified image was used. Radiation exposure was measured at four locations corresponding to the approximate position of the surgeon's head, chest, and groin and the patient's hand. Results: The amount of radiation exposure to both: the surgeon and the patient was significantly less when the c-arm was used in the inverted position (p < 0.0001). The dose rate to the patient's hand was reduced by 59%. The radiation exposure to the surgeon's head, body, and: groin with the inverted-c-arm technique was 67%, 45%, and 15% of the measured doses with the x-ray-tube-down configuration. When we used the magnification mode of the image intensifier, with its correspondingly smaller field size, the doses were further reduced to 46%, 32% and 11% of the standard-configuration values. Conclusions: Use of the inverted-c-arm technique with the image intensifier as an operating table can significantly reduce radiation exposure to the surgeon and the patient during surgical procedures on upper extremities.