Enhanced catalytic performance of Zr modified CuO/ZnO/Al2O3 catalyst for methanol and DME synthesis via CO2 hydrogenation

Zirconium (Zr) modified CuO/ZnO/Al2O3 (CZA) catalysts with different aluminum (Al) and Zr contents were synthesized by the co-precipitation method. The synthesized CuO/ZnO/ZrO2/Al2O3(CZZA) catalysts were comprehensively characterized and studied for methanol synthesis via CO2 hydrogenation. The CZZA catalyst showed the highest methanol yield of 12.4 % at 220 degrees C and 2.76 MPa with an optimized catalyst composition of Cu/Zn/Zr/Al (atomic ratio) at 4:2:1:0.5. The CZZA catalyst showed better activity than that of the CZA catalyst and a superior stability for methanol synthesis. There was no decrease in the BET surface area and very lithe coke formation for the spent CZZA catalyst, after 300 h of methanol synthesis. Bifunctional catalysts, composed of CZZA and HZSM-5, were investigated for dimethyl ether (DME) synthesis directly from CO2 hydrogenation, and a maximum DME yield of 18.3 % was obtained at a reaction temperature of 240 degrees C and a pressure of 2.76 MPa. The stability of the bifunctional CZZA and HZSM-5 catalyst during the DME synthesis also significantly improved, as compared to that of the CZA and HZSM-5. A significant decrease in the BET surface area and an increase in coking on the spent CZZA catalyst were observed after 100 h of DME synthesis, indicating a detrimental effect on CZZA stability when a HZSM-5 catalyst was present. The changes in structural properties (e.g., BET surface area and crystallinity) and coking for HZSM-5 could be responsible for the deactivation of the bifunctional catalyst.