Effects of the heterogeneity in the electron beam welded joint on fatigue crack growth in Ti-6Al-4V alloy

被引：39
作者：
Li, Xingzhi [1 ]
Hu, Shubing [1 ]
Xiao, Jianzhong [1 ]
Ji, Longbo [1 ]
机构：
[1] Huazhong Univ Sci & Technol, State Key Lab Mat Proc & Die Mould Technol, Wuhan 430074, Peoples R China
来源：
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING | 2011年 / 529卷
关键词：
Titanium alloys; Fatigue; Heterogeneity; Electron beam welding; TITANIUM-ALLOY; RESIDUAL-STRESS; MICROSTRUCTURE; BEHAVIOR; PROPAGATION; FRACTURE; PLATE;
D O I：
10.1016/j.msea.2011.09.014
中图分类号：
TB3 [工程材料学];
学科分类号：
0805 ; 080502 ;
摘要：
The heterogeneity of electron beam (EB)-welded joints in thick Ti-6Al-4V alloy plates is defined and described. The microstructure, hardness, and fatigue crack growth rate (FCGR) in the fuse zone (FZ) and the heat-affected zone (HAZ) of thick Ti-6Al-4V alloy EB-welded joint are studied using a new testing and interception method. The fatigue fractographs, crack growth paths and the microscopic deformation are observed through scanning and transmission electron microscopy. The effect mechanism of heterogeneity in the electron beam weld joint to FCGRs is discussed. The results reveal that FCGR is higher in the HAZ than in the FZ, mainly because of the effect of heterogeneity! of the welded joint. Heterogeneity II increases from the top to the root of the welding seam while the size of the alpha' phase decreases. Consequently, FCGR is higher at the root of the welding seam. Heterogeneity in the joint is found to greatly influence the FCGR. Crown Copyright (C) 2011 Published by Elsevier B.V. All rights reserved.
引用
收藏
页码：170 / 176
页数：7
相关论文
共 50 条
  • [41] Quasi-static and dynamic tensile behaviors in electron beam welded Ti-6Al-4V alloy
    Zhang Jing
    Tan Cheng-wen
    Ren Yu
    Wang Fu-chi
    Cai Hong-nian
    [J]. TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA, 2011, 21 (01) : 39 - 44
  • [42] An investigation of the effects of colony microstructure on fatigue crack growth in Ti-6Al-4V
    Sinha, V
    Soboyejo, WO
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2001, 319 : 607 - 612
  • [43] Numerical Prediction of the Fatigue Crack Growth Rate in SLM Ti-6Al-4V Based on Crack Tip Plastic Strain
    Ferreira, Fabio F.
    Neto, Diogo M.
    Jesus, Joel S.
    Prates, Pedro A.
    Antunes, Fernando V.
    [J]. METALS, 2020, 10 (09) : 1 - 22
  • [44] Fatigue resistance of powder metallurgy Ti-6Al-4V alloy
    Ivasishin O.M.
    Bondareva K.A.
    Bondarchuk V.I.
    Gerasimchuk O.N.
    Savvakin D.G.
    Gryaznov B.A.
    [J]. Strength of Materials, 2004, 36 (3) : 225 - 230
  • [45] Heat Treatment to Improve Fatigue Strength of Friction Stir Welded Ti-6Al-4V Alloy Butt Joint
    Nakai, Masaaki
    Niinomi, Mitsuo
    Ishida, Yu
    Liu, Huihong
    Fujii, Hidetoshi
    Ninomiya, Takashi
    [J]. MATERIALS TRANSACTIONS, 2017, 58 (08) : 1223 - 1226
  • [46] Cr/CrN coating effect on the fatigue crack nucleation period of Ti-6Al-4V alloy
    Fernandes, Martin Ferreira
    de Oliveira Velloso, Veronica Mara
    Callisaya, Emanuele Schneider
    Voorwald, Herman Jacobus Cornelis
    [J]. MATERIALS TODAY COMMUNICATIONS, 2024, 38
  • [47] Effect of Superplastic Forming Exposure on Fatigue Crack Propagation Behavior of Ti-6Al-4V Alloy
    Jeong, Daeho
    Kwon, Yongnam
    Goto, Masahiro
    Kim, Sangshik
    [J]. METALS AND MATERIALS INTERNATIONAL, 2016, 22 (05) : 747 - 754
  • [48] Inhomogeneous Fatigue Characteristics of Welded Ti-6Al-4V Thick Plate by the Electron Beam Method
    Wang, Haiyan
    Zeng, Caiyou
    Zhang, Yupeng
    Zhou, Yu
    Dong, Chunlin
    [J]. METALS AND MATERIALS INTERNATIONAL, 2021, 27 (11) : 4527 - 4535
  • [49] High cycle fatigue and fatigue crack propagation behaviors of β-annealed Ti-6Al-4V alloy
    Jeong D.
    Kwon Y.
    Goto M.
    Kim S.
    [J]. International Journal of Mechanical and Materials Engineering, 2017, 12 (1)
  • [50] Effect of deposition strategies on fatigue crack growth behaviour of wire plus arc additive manufactured titanium alloy Ti-6Al-4V
    Syed, Abdul Khadar
    Zhang, Xiang
    Davis, Alec E.
    Kennedy, Jacob R.
    Martina, Filomeno
    Ding, Jialuo
    Williams, Stewart
    Prangnell, Philip B.
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2021, 814
12345