Economic system optimization of air-cooled organic Rankine cycles powered by low-temperature geothermal heat sources

被引:70
|
作者
Walraven, Daniel [1 ,3 ]
Laenen, Ben [2 ,3 ]
D'haeseleer, William [1 ,3 ]
机构
[1] Univ Louvain, KU Leuven, Energy Inst, TME Branch Applied Mech & Energy Convers, B-3001 Louvain, Belgium
[2] Flemish Inst Technol Res VITO, B-2400 Mol, Belgium
[3] Energy Ville, B-3600 Genk, Belgium
关键词
ORC (organic Rankine cycle); Geothermal; Air-cooled condenser; Economics; Optimization; FRICTION CHARACTERISTICS; ORC; EXPLOITATION; EXCHANGERS; PLANTS; FLOW; PART;
D O I
10.1016/j.energy.2014.11.048
中图分类号
O414.1 [热力学];
学科分类号
摘要
In this paper, an economic system optimization of an air-cooled organic Rankine cycle, powered by geothermal heat, is performed. The goal is to find the configuration of the ORC (organic Rankine cycle) which gives the highest possible net present value for the project. The cycle parameters, heat exchanger geometry and air-cooled condenser geometry are optimized together. The developed method is applied to a case study, based on a Belgian geothermal project, after which the most important parameters are varied. It is shown that the air-cooled condenser is a crucial component from both a thermodynamic and economic point of view. The discount rate, electricity price, brine inlet temperature and annual electricity price evolution have a strong influence on the configuration and efficiency of the ORC and on the economics of the project. (C) 2014 Elsevier Ltd. All rights reserved.
引用
收藏
页码:104 / 113
页数:10
相关论文
共 50 条
  • [1] Exergoeconomic Optimization of an Organic Rankine Cycle for Low-Temperature Geothermal Heat Sources
    Heberle, F.
    Bassermann, P.
    Preissinger, M.
    Brueggemann, D.
    INTERNATIONAL JOURNAL OF THERMODYNAMICS, 2012, 15 (02) : 119 - 126
  • [2] Minimizing the levelized cost of electricity production from low-temperature geothermal heat sources with ORCs: Water or air cooled?
    Walraven, Daniel
    Laenen, Ben
    D'haeseleer, William
    APPLIED ENERGY, 2015, 142 : 144 - 153
  • [3] Design Sensitivity Analysis of a Plate-Finned Air-Cooled Condenser for Low-Temperature Organic Rankine Cycles
    Kaya, Alihan
    Lazova, Marija
    Bagci, Ozer
    Lecompte, Steven
    Ameel, Bernd
    De Paepe, Michel
    HEAT TRANSFER ENGINEERING, 2017, 38 (11-12) : 1018 - 1033
  • [4] Design and off-design optimization procedure for low-temperature geothermal organic Rankine cycles
    Van Erdeweghe, Sarah
    Van Bael, Johan
    Laenen, Ben
    D'haeseleer, William
    APPLIED ENERGY, 2019, 242 : 716 - 731
  • [5] Thermodynamic and economic optimization of a double-pressure organic Rankine cycle driven by low-temperature heat source
    Sun, Qingxuan
    Wang, Yaxiong
    Cheng, Ziyang
    Wang, Jiangfeng
    Zhao, Pan
    Dai, Yiping
    RENEWABLE ENERGY, 2020, 147 : 2822 - 2832
  • [6] An iterative method for modelling the air-cooled organic Rankine cycle geothermal power plant
    Sohel, M. Imroz
    Sellier, Mathieu
    Brackney, Larry J.
    Krumdieck, Susan
    INTERNATIONAL JOURNAL OF ENERGY RESEARCH, 2011, 35 (05) : 436 - 448
  • [7] Investigation on working fluids selection for organic rankine cycles with low-temperature heat sources
    Guo, Cong
    Du, Xiaoze
    Goswami, D. Yogi
    Yang, Lijun
    INTERNATIONAL JOURNAL OF GREEN ENERGY, 2016, 13 (06) : 556 - 565
  • [8] Performance optimization of low-temperature geothermal organic Rankine cycles using axial turbine isentropic efficiency correlation
    Zhang, Chao
    Fu, Jinglun
    Kang, Jun
    Fu, Wencheng
    JOURNAL OF THE BRAZILIAN SOCIETY OF MECHANICAL SCIENCES AND ENGINEERING, 2018, 40 (02)
  • [9] Comparison of thermodynamic cycles for power production from low-temperature geothermal heat sources
    Walraven, Daniel
    Laenen, Ben
    D'haeseleer, William
    ENERGY CONVERSION AND MANAGEMENT, 2013, 66 : 220 - 233
  • [10] Thermo-economic optimization of waste heat recovery Organic Rankine Cycles
    Quoilin, Sylvain
    Declaye, Sebastien
    Tchanche, Bertrand F.
    Lemort, Vincent
    APPLIED THERMAL ENGINEERING, 2011, 31 (14-15) : 2885 - 2893