Repair of damaged mold surface by cold-spray method

被引：70
作者：
Lee, J. C. [1 ]
Kang, H. J. [1 ]
Chu, W. S. [1 ]
Ahn, S. H. [1 ]
Oh, S. I. [1 ]
机构：
[1] Seoul Natl Univ, Sch Mech & Aerosp Engn, Seoul, South Korea
来源：
CIRP ANNALS-MANUFACTURING TECHNOLOGY | 2007年 / 56卷 / 01期
基金：
欧洲研究理事会;
关键词：
surface; mold; deposition;
D O I：
10.1016/j.cirp.2007.05.138
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
Thermal-mechanical loads during molding can cause wearing of the surfaces of the molds. In this research, a mold repair technique at low temperature was developed by applying cold-spray deposition. Aluminum particles were deposited on top of the damaged aluminum mold. The original mold surface was recovered by milling the deposited material. Material properties such as hardness, coefficient of thermal expansion, chemical composition, wear resistance, and machinability of the mold and repaired layer were characterized. To verify the recovered molding capability, polymer (Polystyrol) products were fabricated by injection molding using the repaired mold. Experimental results showed that the mold repair process using cold-spray deposition and machining can be applied in the mold repair industry.
引用
收藏
页码：577 / 580
页数：4
相关论文
共 17 条
  • [1] CHOI J, 2001, P DETC 01 ASME DETC2
  • [2] Direct laser freeform fabrication of high performance metal components
    Das, Suman
    Beaman, Joseph J.
    Wohlert, Martin
    Bourell, David L.
    [J]. RAPID PROTOTYPING JOURNAL, 1998, 4 (03) : 112 - 117
  • [3] Davies MA, 1998, CIRP ANNALS 1998 - MANUFACTURING TECHNOLOGY, VOL 47, NO 1, V47, P55
  • [4] FAILDR J, 1995, MATER EVAL, P369
  • [5] Experimental fretting-wear studies of steam generator materials
    Fisher, NJ
    Chow, AB
    Weckwerth, MK
    [J]. JOURNAL OF PRESSURE VESSEL TECHNOLOGY-TRANSACTIONS OF THE ASME, 1995, 117 (04): : 312 - 320
  • [6] Particle velocity and deposition efficiency in the cold spray process
    Gilmore, DL
    Dykhuizen, RC
    Neiser, RA
    Roemer, TJ
    Smith, MF
    [J]. JOURNAL OF THERMAL SPRAY TECHNOLOGY, 1999, 8 (04) : 576 - 582
  • [7] Hyuk-Jin Kang, 2006, International Journal of Precision Engineering and Manufacturing, V7, P57
  • [8] KANG HJ, 2007, J COREA SOC PRECISIO, V24, P47
  • [9] LEE JC, 2006, J COREA SOC PRECISIO, V23, P88
  • [10] Li XP, 1999, J MATER PROCESS TECH, V90, P266
12