Adaptive autoregressive modeling of non-stationary vibration signals under distinct gear states. Part 2: experimental analysis

Parametric time-frequency representation based on parametric models is more desirable for presenting highly precise time-frequency domain information due to its high-resolution property. However, the sensitivity and robustness of parametric models, in particular the parametric models on the basis of advanced adaptive filtering algorithms, has never been investigated for on-line condition monitoring of rotating machinery. Part I of this study proposed three adaptive parametric models based on three advanced adaptive filtering algorithms. Part 2 of this study is concerned with the effectiveness of the proposed models under distinct gear states, especially the highly non-stationary conditions accrued from advanced gear faults. Four gear states are considered: healthy state, adjacent gear tooth failure, non-adjacent gear tooth failure and distributed gear tooth failure. The vibration signals used in this study include the time-domain synchronous averaging signal and gear motion residual signal for each considered gear state. The test results demonstrate that the optimum filter behavior can readily be attained and the white Gaussian assumption of innovations can relatively be easily guaranteed for the NAKF-based model under distinct gear states and a wide variety of model initializations. On the other hand, the EKF- and MEKF-based models are capable of generating more accurate time-frequency representations than the NAKF-based model, but in general the optimality condition for white Gaussian assumption cannot be guaranteed for these two advanced models. Therefore, the NAKF-based model is preferred for automatic condition monitoring due to its appealing robustness to distinct gear states and arbitrary model initializations, whereas the EKF- and MEKF-based models are desirable when accurate time-frequency representation is concerned. (c) 2004 Elsevier Ltd. All rights reserved.