The performances of palm mid olein as lubricant in journal bearing application

被引:0
|
作者
Zulhanafi, P. [1 ]
Syahrullail, S. [1 ]
Ahmad, Mohamad Ali [2 ]
机构
[1] Univ Teknol Malaysia, Fac Mech Engn, Skudai 81310, Johor, Malaysia
[2] Univ Teknol MARA, Fac Mech Engn, Shah Alam 40450, Selangor, Malaysia
来源
PROCEEDINGS OF ASIA INTERNATIONAL CONFERENCE ON TRIBOLOGY 2018 (ASIATRIB 2018) | 2018年
关键词
Journal bearing; palm mid olein; hydrodynamic lubricant;
D O I
暂无
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
Journal bearing is one of the major components especially for the equipment dealing with continuous rotating speeds and heavy load. Lubricant also plays an important role to determine the performance of journal bearing. In this study, the pressure distribution of Palm Mid Olein (PMO) lubricant was investigated along the bearing circumferences and compared with Mineral oil based lubricant (SAE 40) using journal bearing test rig. It was found that at lower load, PMO presented higher maximum pressure compared to SAE 40. It was also observed that the increase in radial load caused an increase in maximum pressure. However, the position of maximum pressure has not changed with increasing radial loads.
引用
收藏
页码:382 / 383
页数:2
相关论文
共 48 条
  • [41] Performance of externally pressurized non-recessed roughened journal bearing system operating with non-Newtonian lubricant
    Nagaraju, T
    Sharma, SC
    Jain, SC
    TRIBOLOGY TRANSACTIONS, 2003, 46 (03) : 404 - 413
  • [42] Thermal Analysis of Journal bearing with controlled slip/no-slip boundary condition and Non-Newtonian Rheology of lubricant
    Arif, Mohammad
    Kango, Saurabh
    Kumar Shukla, Dinesh
    SURFACE TOPOGRAPHY-METROLOGY AND PROPERTIES, 2021, 9 (02)
  • [43] A study of cavitation effect in a journal bearing using CFD: A case study of engine oil, palm oil and water
    Rasep, Zuraidah
    Yazid, Muhammad Noor Afiq Witri Muhammad
    Samion, Syahrullail
    JURNAL TRIBOLOGI, 2021, 28 : 48 - 62
  • [44] A novel method to evaluate the journal bearing forces with application to flexible rotor model
    Sayed, Hussein
    El-Sayed, T. A.
    TRIBOLOGY INTERNATIONAL, 2022, 173
  • [45] THERMOHYDRODYNAMIC ANALYSIS OF A JOURNAL BEARING IN A TURBULENT-FLOW REGIME .2. APPLICATION TO AN AXIAL GROOVE BEARING
    LIN, JF
    CHEN, YN
    TRIBOLOGY TRANSACTIONS, 1994, 37 (04) : 820 - 828
  • [46] Dynamic characteristics of magnetorheological fluid lubricated journal bearing and its application to rotor vibration control
    Wang, Xiaohu
    Li, Hongguang
    Li, Ming
    Bai, Huiyu
    Meng, Guang
    Zhang, Hua
    JOURNAL OF VIBROENGINEERING, 2015, 17 (04) : 1912 - 1928
  • [47] Application of artificial neural network for lubrication performance evaluation of rough elliptic bore journal bearing
    Pradhan, Sushanta Kumar
    Mishra, Prabhudatta
    Mishra, Prakash Chandra
    JOURNAL OF COMPUTATIONAL DESIGN AND ENGINEERING, 2022, 9 (02) : 279 - 295
  • [48] Hybrid feature selection method for SVM classification and its application for fault diagnosis of wear and peeling in journal bearing with a little muddy water using long-term real data
    Tu, Yilin
    Inoue, Tsuyoshi
    Yabui, Shota
    Katayama, Keiichi
    Tomimatsu, Shigeyuki
    JOURNAL OF LOW FREQUENCY NOISE VIBRATION AND ACTIVE CONTROL, 2023, 42 (01) : 231 - 252