Effects of reactors on the deposition of DLC films using liquid electrochemical technique

被引:2
|
作者
He, Y. Y. [1 ,2 ]
Zhang, G. F. [3 ]
Buck, V. [1 ,2 ]
机构
[1] Univ Duisburg Essen, Fac Phys, Thin Film Technol Grp, D-47057 Duisburg, Germany
[2] CeNIDE, D-47057 Duisburg, Germany
[3] Dalian Univ Technol, Sch Mat Sci & Engn, Dalian 116024, Peoples R China
关键词
DLC films; Liquid electrochemical technique; Reactors; DIAMOND-LIKE CARBON; RAMAN-SPECTROSCOPY; AMORPHOUS-CARBON; LOW-TEMPERATURE;
D O I
10.1016/j.diamond.2010.10.004
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Carbon films were deposited on silicon substrates by liquid electrochemical technique at low temperature (60 degrees C) in ambient atmosphere. Glass reactor, glass reactor with PTFE-coating inside, glass reactor with quartz-coating inside and quartz reactor were used with the same experimental setup to compare the effects of reactors on the deposition of carbon films. The applied potential, the distance between anode and substrate and the deposition time were fixed at 900 V (4.2 kHz, 50%), 6 mm and 5 h, respectively. The morphology and microstructure of the films were analyzed by scanning electron microscopy (SEM) and Raman spectroscopy. Energy Dispersive X-ray Spectrometry (EDX) was used to measure the composition of the films. The SEM observations showed that the films deposited using glass reactor were composed of crystals of several micrometers which contained nearly 10 at.% of Ca. Raman spectroscopy analysis confirmed that DLC films have been deposited, but with an obvious sharp peak at 1085 cm(-1) which is assigned to calcium carbonate (CaCO(3)) crystals. The glass reactor is the possible source of Ca because the electrolyte was composed of analytically pure acetone and deionized water with the proportion of Ca below the determination of AAS (atomic absorption emission spectrophotometer AA-6200). Using glass reactor with PTFE-coating inside could successfully avoid the impurity of Ca from the glass reactor, but new non-metallic impurities coming from the PTFE-coating made the films rough. Continuous and smooth films were deposited by using a glass reactor with quartz-coating inside and quartz reactor, which could avoid both Ca (< 1 at.%) and other impurities. Raman spectroscopy analysis confirmed typical DLC films without CaCO(3). It can be concluded that the materials of the reactors could play an important role not only in the composition, but also the morphology and microstructure of films deposited by liquid electrochemical technique. (C) 2010 Elsevier B.V. All rights reserved.
引用
收藏
页码:97 / 100
页数:4
相关论文
共 50 条
  • [31] Ion beam deposition of DLC and nitrogen doped DLC thin films for enhanced haemocompatibility on PTFE
    Srinivasan, S.
    Tang, Y.
    Li, Y. S.
    Yang, Q.
    Hirose, A.
    APPLIED SURFACE SCIENCE, 2012, 258 (20) : 8094 - 8099
  • [32] Aroused problems in the deposition of diamond-like carbon films by using the liquid phase electrodeposition technique
    Jiu, JT
    Fu, Q
    Wang, H
    Zhu, HS
    JOURNAL OF INORGANIC MATERIALS, 2002, 17 (03) : 571 - 578
  • [33] Microstructure and properties of (Cr:N)-DLC films deposited by a hybrid beam technique
    Yang, Wei
    Guo, Yongchun
    Xu, Dapeng
    Li, Jinhua
    Wang, Ping
    Ke, Peiling
    Wang, Aiying
    SURFACE & COATINGS TECHNOLOGY, 2015, 261 : 398 - 403
  • [34] Low energy repetitive miniature plasma focus device as high deposition rate facility for synthesis of DLC thin films
    Ghareshabani, E.
    Rawat, R. S.
    Verma, R.
    Karamat, S.
    Sobhanian, S.
    APPLIED SURFACE SCIENCE, 2010, 256 (16) : 4977 - 4983
  • [35] Deposition and Tribological Properties of Sulfur-Doped DLC Films Deposited by PBII Method
    Moolsradoo, Nutthanun
    Watanabe, Shuichi
    ADVANCES IN MATERIALS SCIENCE AND ENGINEERING, 2010, 2010
  • [36] Pulsed DC plasma CVD system for the deposition of DLC films
    Al Mamun, Md Abdullah
    Furuta, Hiroshi
    Hatta, Akimitsu
    MATERIALS TODAY COMMUNICATIONS, 2018, 14 : 40 - 46
  • [37] Influence of deposition parameters on RF sputtered DLC thin films
    Caneve, L
    Rizzo, A
    Sarto, F
    Scaglione, S
    ADVANCES IN OPTICAL INTERFERENCE COATINGS, 1999, 3738 : 34 - 39
  • [38] DEPOSITION OF WIDE BAND GAP DLC FILMS USING RF PECVD AT VERY LOW POWER
    Barhai, P. K.
    Sharma, Rishi
    Nayak, B. B.
    INTERNATIONAL JOURNAL OF MODERN PHYSICS B, 2011, 25 (29): : 3941 - 3949
  • [39] Fabrication of ZnO nanoparticles-embedded hydrogenated diamond-like carbon films by electrochemical deposition technique
    Zhang Pei-Zeng
    Li Rui-Shan
    Pan Xiao-Jun
    Xie Er-Qing
    CHINESE PHYSICS B, 2013, 22 (05)
  • [40] Environmental effects on the friction of hydrogenated DLC films©
    Kim, H. I.
    Lince, J. R.
    Eryilmaz, O. L.
    Erdemir, A.
    TRIBOLOGY & LUBRICATION TECHNOLOGY, 2006, 62 (08): : 38 - 42