Tensile strength and fiber/matrix interfacial properties of 2D-and 3D-carbon/carbon composites

被引：51

作者：

Hatta, H

Goto, K

Ikegaki, S

Kawahara, I

Aly-Hassan, MS

Hamada, H

机构：

[1] Japan Aerosp Explorat Agcy, Inst Space & Astronaut Sci, Res Div Space Struct & Mat, Sagamihara, Kanagawa 2298510, Japan

[2] Kyoto Inst Technol, Sakyo Ku, Matsugasaki, Kyoto 6068585, Japan

[3] Kogakuin Univ, Grad Sch Engn, Hachioji, Tokyo 1920015, Japan

来源：

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY | 2005年 / 25卷 / 04期

关键词：

C/C composites; strength; interfaces; HIP; residual stresses;

D O I：

10.1016/j.jeurceramsoc.2004.02.014

中图分类号：

TQ174 [陶瓷工业]; TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

The tensile and fiber/matrix interfacial properties of 2D and 3D carbon/carbon composites (C/C) were compared. To elucidate the effect of three-dimensional reinforcement, both C/Cs were composed of the same constituents and prepared via. the same process route. The tensile fracture strain of both C/Cs degraded with increasing bulk density, and the fracture strain of the 3D-C/Cs were larger than that of the 2D-C/Cs at the same bulk density. The interfacial bonding strength of the 3D-C/Cs were found to be much lower than that of the 2D-C/Cs. From the comparison of the interfacial and tensile fracture behavior, high tensile fracture strains of 3D-C/Cs were concluded to be attributed to the weak interfacial bonding. This low interfacial strength of the 3D-C/Cs was suggested to be caused by the residual stresses induced during processing in the 3D-C/Cs due to three-dimensional restriction of the fibers. (C) 2004 Elsevier Ltd. All rights reserved.

引用

页码：535 / 542

页数：8

共 26 条

[21]

Schmidt DL, 1999, SAMPE J, V35, P27

[22] Damage and failure mechanisms of a 3-directional carbon/carbon composite under uniaxial tensile and shear loads [J].

Siron, O ;

Lamon, J .

ACTA MATERIALIA, 1998, 46 (18) :6631-6643

[23] Mechanical properties of C C composites [J].

Thielicke, B .

HIGH TEMPERATURE CERAMIC MATRIX COMPOSITES III, 1999, 164-1 :145-150

[24] EFFECT OF INTERFACE MECHANICAL-PROPERTIES ON PULLOUT IN A SIC-FIBER-REINFORCED LITHIUM ALUMINUM SILICATE GLASS-CERAMIC [J].

THOULESS, MD ;

SBAIZERO, O ;

SIGL, LS ;

EVANS, AG .

JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 1989, 72 (04) :525-532

[25]

TROUVAT B, 1997, TOUGHENING MECH C C, V2, P536

[26] MECHANISMS OF DEFORMATION AND FAILURE IN CARBON-MATRIX COMPOSITES SUBJECT TO TENSILE AND SHEAR LOADING [J].

TURNER, KR ;

SPECK, JS ;

EVANS, AG .

JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 1995, 78 (07) :1841-1848

← 1 2 3 →