The Canadian oil sands deposits in northern Alberta contain about 1.3 trillion barrels of crude oil equivalent. The largest of the four major fort-nations is found in the Athabasca region where bitumen is heterogeneously distributed throughout an unconsolidated mineral matrix. About one-tenth of the oil sands in this deposit is economically recoverable by conventional surface mining techniques. The Hot Water Extraction Process (HWEP) is used commercially to recover bitumen from surface mined oil sands ore. The viability of this process relies on the existence of a thin water film around each solid particle in the ore matrix. However, a completely water-wet mineral condition is not generally the case for oil reservoirs, including oil sands deposits. In the latter case, it has been shown that certain solid fractions are associated with significant amounts of toluene insoluble organic matter (TIOM), physically or chemically adsorbed onto particle surfaces. These fractions are generically described as 'organic rich solids' (ORS). In bitumen separation processes, the organic matter associated with various ORS fractions represents an impediment to optimum bitumen separation and upgrading. In this sense, these solids are considered to be 'active' relative to the inactive' water wetted quartz particles comprising the bulk of the oil sands ore. Preliminary results indicate that the ORS content of an ore appears to be a better predictor for ore processability than the traditional use of bitumen or fines ( -44 mum) contents. Two types of ORS have received particular attention. The first is a coarser fraction, usually less than 44 mum but also occurring as particles greater than 100 mum in diameter. This material typically occurs as aggregates of smaller particles bound together by humic matter and precipitated minerals. During the bitumen separation process, these heavy aggregates carry any associated bitumen into the aqueous tailings, thus reducing overall bitumen recovery. The second important fraction comprises very thin, ultra-fine clay particles with a major dimension of < 0.3 mum. These ultra-fine clays, with a surface coating of organic matter, remain with bitumen during the separation process. In bitumen upgrading, these solids may be entrained with volatile overheads and cause problems in downstream operations. This paper summarises the protocols developed to separate and characterise these intractable components from HWEP process streams and discusses their role in determining bitumen recovery and quality. Crown Copyright (C) 2003 Published by Elsevier Science B.V. All rights reserved.
