Air-side heat transfer enhancement of a refrigerator evaporator using vortex generation

In most domestic and commercial refrigeration systems, frost forms on the air-side surface of the air-to-refrigerant heat exchanger. Frost-tolerant designs typically employ a large fin spacing in order to delay the need for a defrost cycle. Unfortunately, this approach does not allow for a very high air-side heat transfer coefficient, and the performance of these heat exchangers is often air-side limited. Longitudinal vortex generation is a proven and effective technique for thinning the thermal boundary layer and enhancing heat transfer, but its efficacy in a frosting environment is essentially unknown. In this study, an array of delta-wing vortex generators is applied to a plain-fin-and-tube heat exchanger with a fin spacing of 8.5 mm. Heat transfer and pressure drop performance are measured to determine the effectiveness of the vortex generator under frosting conditions. For air-side Reynolds numbers between 500 and 1300, the air-side thermal resistance is reduced by 35-42% when vortex generation is used. Correspondingly, the heat transfer coefficient is observed to range from 33 to 53 W m(-2) K-1 for the enhanced heat exchanger and from 18 to 26 W m(-2) K-1 for the baseline heat exchanger. (c) 2005 Elsevier Ltd and IIR. All rights reserved.